English

What do the following symbols mean in circuit diagrams? Variable resistance or rheostat

Advertisements
Advertisements

Question

What do the following symbols mean in circuit diagrams?  

One Line Answer
Advertisements

Solution

Variable resistance or rheostat. A rheostat is used to change the resistance in a circuit.

shaalaa.com
  Is there an error in this question or solution?
Chapter 4: Electricity - Exercise 2 [Page 196]

APPEARS IN

Lakhmir Singh Physics Part 1 [English] Class 10
Chapter 4 Electricity
Exercise 2 | Q 11. (a) | Page 196

RELATED QUESTIONS

Draw a schematic diagram of a circuit consisting of a battery of three cells of 2 V each, a 5 Ω resistor, an 8 Ω resistor, and a 12 Ω resistor, and a plug key, all connected in series.


Redraw the circuit of question 1, putting in an ammeter to measure the current through the resistors and a voltmeter to measure the potential difference across the 12 Ω resistors. What would be the readings in the ammeter and the voltmeter?


Draw circuit symbols for  

an open switch


Draw a circuit diagram to show how 3 bulbs can be lit from a battery so that 2 bulbs are controlled by the same switch the third bulb has its own switch. 

 


Explain the construction and working of the following. Draw a neat diagram and label it.

Electric motor


In an electric circuit, a battery and a bulb have been connected and the battery consists of two cells of equal potential difference. If the bulb is not glowing, then which tests will you perform in order to find out the reason for the bulb not glowing?


Name the instrument used to control current in an electric circuit.


How much is the potential difference between live and neutral wires?


______ is the device used to close or open an electric circuit.


In which of the following circuits are the bulb connected in series?


Higher Order Question

A student made a circuit by using an electric cell, a switch, a torch bulb (fitted in the bulb holder), and copper connecting wires. When he turned on the switch, the torch bulb did not glow at all. The student checked the circuit and found that all the wire connections were tight.

  • What could be the possible reason for the torch bulb not glowing even when the circuit appears to be complete?

Three bulbs are connected end to end from the battery. This connection is called _______.


When a circuit is open, _____ cannot pass through it.


The wiring in a house consists of ______ circuits.


The rate of flow of electric charges in a circuit is called ______.


In an electrical circuit two resistors of 2 Ω and 4 Ω respectively are connected in series to a 6 V battery. The heat dissipated by the 4 Ω resistor in 5 s will be


Our body is a ______ of electricity.


In the above circuit, if the current reading in the ammeter A is 2A, what would be the value of R1? 


Boojho has a cell and a single piece of connecting wire. Without cutting the wire in two, will he be able to make the bulb glow? Explain with the help of a circuit diagram.


Write a short note on the different electrical circuits.


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×