Advertisements
Advertisements
Question
How does the short circuit form?
Advertisements
Solution
A short circuit occurs when the live and neutral wires come into contact due to damaged insulation or a fault in an appliance. This causes a large current to flow.
APPEARS IN
RELATED QUESTIONS
Draw circuit symbols for
a cell
Draw the labelled diagram of an electric circuit comprising of a cell, a resistance, an ammeter, a voltmeter and a closed switch (or closed plug key). Which of the two has a large resistance : an ammeter or a voltmeter?
Explain with the help of a labelled circuit diagram how you will find the resistance of a combination of three resistors, or resistance R1, R2 and R3, joined in parallel. Also mention how you will connect the ammeter and the voltmeter in the circuit when measuring the current in the circuit and the potential difference across one of the three resistors of the combination.
Tell the odd one out. Give a proper explanation.
Explain the construction and working of the following. Draw a neat diagram and label it.
Electric motor
Observe the following figure which bulb get fuse?
What do you understand by the closed electric circuit
What do you understand by the open electric circuit?
Name the instrument used to control current in an electric circuit.
If you touch an electric wire carrying current you get a shock, but if on the same wire the birds sit they do not get any shock/current. Explain why?
What is the potential difference?
What is the use of earthing wire?
______ is the device used to close or open an electric circuit.
Rahul wants to make an electric circuit. He has a bulb, two wires, a safety pin, and a piece of copper. He does not have any electric cell or battery. Suddenly he gets some idea. He uses lemon instead of a battery and makes a circuit. Will the bulb glow?
In the circuit shown, which switches (L,M or N) must be closed to light up the bulb?
In which of the following circuits are the bulb connected in series?
Draw the circuit diagram for the following series connection
_____ has a thin metallic filament that melts and breaks the connection when the circuit is overheated.
Three bulbs are connected end to end from the battery. This connection is called _______.
What is electric circuit?
When a circuit is open, _____ cannot pass through it.
Instead of metal wires, a jute string can be used to make a circuit.
What are the types of electric circuits?
In the following circuits (Figure), heat produced in the resistor or combination of resistors connected to a 12 V battery will be
 |
 |
 |
| (i) | (ii) | (iii) |
In an electrical circuit three incandescent bulbs A, B and C of rating 40 W, 60 W and 100 W respectively are connected in parallel to an electric source. Which of the following is likely to happen regarding their brightness?
Choose the statement which is not correct in the case of an electric fuse.
Three bulbs A, B, C are connected in a circuit as shown in the following figure. When the switch is ‘ON’
The ______ is a species of fish that can give electric shocks of up to six hundred fifty watts of electricity.
In the following arrangement shown in the following figure, the bulb will not glow if the ends A and B are connected with
A complete circuit is left on for several minutes, causing the connecting copper wire to become hot. As the temperature of the wire increases, the electrical resistance of the wire
An electric motor rated 1100 W is connected to 220 V mains. Find:
- The current drawn from the mains,
- Electric energy consumed if the motor is used for 5 hours daily for 6 days.
- Total cost of energy consumed if the rate of one unit is 5.
How is Joule's law effect useful in electric circuits where fuse is used as a safety device?
Assertion: People struck by lightning receive a severe electrical shock.
Reason: Lightning carries very high voltage.
Set up the circuit shown in Figure again. Move the key to ‘ON’ position and watch carefully in which direction the compass needle gets deflected. Switch ‘OFF’ the current. Now keeping rest of the circuit intact, reverse the connections at the terminal of the cell. Again switch ‘on’ the current. Note the direction in which the needle gets deflected. Think of an explanation.
