Advertisements
Advertisements
Question
Draw a circuit diagram to show how 3 bulbs can be lit from a battery so that 2 bulbs are controlled by the same switch the third bulb has its own switch.
Advertisements
Solution
Here is the circuit diagram that shows how three bulbs can be lit from a battery so that two bulbs are controlled by the same switch. The third bulb has its own switch.
APPEARS IN
RELATED QUESTIONS
Redraw the circuit of question 1, putting in an ammeter to measure the current through the resistors and a voltmeter to measure the potential difference across the 12 Ω resistors. What would be the readings in the ammeter and the voltmeter?
What is a circuit diagram
How does the short circuit form?
A battery is to be formed by joining 3 dry cells with connecting wires. Show how will you connect the wires by drawing a diagram.
Draw a neat diagram showing a closed electric circuit.
Explain the following:
Closed circuit
In the circuit shown, which switches (L,M or N) must be closed to light up the bulb?
In which of the following circuits are the bulb connected in series?
Study the electric circuit below. Which of the following switches should be closed so that only two bulbs will light up
Three bulbs are connected end to end from the battery. This connection is called _______.
State whether true or false. If false, correct the statement.
Ammeter is connected in parallel in any electric circuit.
The wiring in a house consists of ______ circuits.
Explain about domestic electric circuits. (circuit diagram not required)
In an electric circuit, the current starts from ______.
In an electric circuit a fuse is a ______ ______ to prevent possible fire.
In the above circuit, if the current reading in the ammeter A is 2A, what would be the value of R1?
Paheli is running short of connecting wires. To complete an electric circuit, she may use a ______.
Set up the circuit shown in Figure again. Move the key to ‘ON’ position and watch carefully in which direction the compass needle gets deflected. Switch ‘OFF’ the current. Now keeping rest of the circuit intact, reverse the connections at the terminal of the cell. Again switch ‘on’ the current. Note the direction in which the needle gets deflected. Think of an explanation.
