Advertisements
Advertisements
प्रश्न
The co-efficient of mutual induction between primary and secondary coil is 2H. Calculate induced e.m.f. if current of 4A is cut off in 2.5 x 10-4 seconds
Advertisements
उत्तर
Here, the co-efficient of mutual induction, M = 2H
4A is cut-off in 2.5 × 10-4 seconds.
Induced e.m.f., E = `M(di)/(dt)`
`therefore E = 2Hxx(4A)/(2.5xx10^-4)`
`therefore E = 3.2 xx 10^4V`
APPEARS IN
संबंधित प्रश्न
If the radius of a sphere is doubled without changing the charge on it, then electric flux originating from the sphere is ______.
Draw a necessary arrangement for winding of primary and secondary coils in a step-up transformer. State its underlying principle and derive the relation between the primary and secondary voltages in terms of number of primary and secondary turns. Mention the two basic assumptions used in obtaining the above relation.
In an experiment, two coils c1 and c2 are placed close to each other. Find out the expression for the emf induced in the coil c1 due to a change in the current through the coil c2.
The current flowing through an inductor of self inductance L is continuously increasing. Plot a graph showing the variation of Magnetic potential energy stored versus the current.
A long solenoid with 15 turns per cm has a small loop of area 2.0 cm2 placed inside the solenoid normal to its axis. If the current carried by the solenoid changes steadily from 2.0 A to 4.0 A in 0.1 s, what is the induced emf in the loop while the current is changing?
An air-cored solenoid with length 30 cm, area of cross-section 25 cm2 and number of turns 500, carries a current of 2.5 A. The current is suddenly switched off in a brief time of 10−3 s. How much is the average back emf induced across the ends of the open switch in the circuit? Ignore the variation in magnetic field near the ends of the solenoid.
Define coefficient of mutual induction.
Explain the phenomenon of mutual induction.
A pair of adjacent coils has a mutual inductance of 1.5 H. If the current in one coil changes from 0 to 20 A in 0.5 s, what is the change of flux linkage with the other coil?
Two circular loops are placed with their centres separated by a fixed distance. How would you orient the loops to have (a) the largest mutual inductance (b) the smallest mutual inductance?
Find the mutual inductance between the straight wire and the square loop of figure.
Find the mutual inductance between the circular coil and the loop shown in figure.
A solenoid of length 20 cm, area of cross-section 4.0 cm2 and having 4000 turns is placed inside another solenoid of 2000 turns having a cross-sectional area 8.0 cm2 and length 10 cm. Find the mutual inductance between the solenoids.
A pair of adjacent coils has a mutual inductance of 1.5 H. If the current in one coil changes from 0 to 10 A in 0.2 s, what is the change of flux linkage with the other coil?
An emf of 96.0 mV is induced in the windings of a coil when the current in a nearby coil is increasing at the rate of 1.20 A/s. What is the mutual inductance (M) of the two coils?
A long solenoid of length l, cross-sectional area A and having N1 turns (primary coil), has a small coil of N2 turns (secondary coil) wound about its center. Determine the Mutual inductance (M) of the two coils.
A pair of the adjacent coil has a mutual inductance of 1.5 H. If the current in one coil varies from 0 to 20 A in 0.5 s, what is the change of flux linked with the other coil.
Two coils P and Q are kept near each other. When no current flows through coil P and current increases in coil Q at the rate 10 A/s, the e.m.f. in coil P is 20 mV. When coil Q carries no current and current of 1.6 A flows through coil P, the magnetic flux linked with the coil Q is ____________.
In mutual induction, the main current remains same because ____________.
In an induction coil, the coefficient of mutual inductance is 6 henry. If a current of 10 ampere in the primary coil is cut-off in `1/1500"s"`, the e.m.f. at the terminals of the secondary coil will be ____________.
An alternating current of frequency 200 rad/s and peak value 1 A is applied to the primary of a transformer. If the coefficient of mutual induction between the primary and the secondary is 1.5H, then the voltage induced in the secondary will be approximately (π = 2217)
Alternating current of peak value `(2/pi)` ampere flows through the primary coil of transformer. The coefficient of mutual inductance between primary and secondary coil is 1 H. The peak e.m.f. induced in secondary coil is ______. (Frequency of a.c. = 50 Hz)
The mutual inductance between two coplanar concentric rings A and B of radii 'R1' and 'R2' placed in air when a current 'I' flows through ring A is (R1 >> R2) (µ0 = permeability of free space) ____________.
The coefficient of mutual inductance is 2H and induced e.m.f. across secondary is 2 kV. Current in the primary is reduced from 6 A and 3A. The time required for the change of current is ____________.
The mutual inductance of a pair of coils is 0.75 H. If current in the primary coil changes from 0.5 A to zero in 0.01 s, find average induced e.m.f. in secondary coil ______.
If number of turns in primary and secondary coils is increased to two times each, the mutual inductance ______.
Two circular coils have their centres at the same point. The mutual inductance between them will be maximum when their axes ______
Two conducting circular loops of radii R1 and R2 are placed in the same plane with their centres coinciding. If R1 > > R2, the mutual inductance M between them will be directly proportional to ______.
Two conducting circular loops of radii R1 and R2 are placed in the same plane with their centres coinciding. If R1 >> R2, the mutual inductance M between them will be directly proportional to ______.
A toroid is a long coil of wire wound over a circular core. The major radius and cross-sectional radius of the toroid are R and r, respectively. The coefficient of mutual induction of the toroid is ______.
(The magnetic field in it is uniform, N = number of turns, R >> r, μ0 = permeability of free space)
Write the S.I. unit of mutual inductance.
The mutual inductance of a pair of adjacent coils is 1.5 H. If the current is one coil changes from 5 A to 10 A in 0.1 s, the rate of change of magnet flux linkage is ______.
State and define the SI unit of mutual inductance.
Two coils having self inductances L1 = 75 mH and L2 = 55 mH are coupled with each other. The coefficient of coupling (K) is 0. 75. Calculate the mutual inductance (M) of the two coils
Two planar concentric rings of metal wire having radii r and r2 (r₁ > r2) are placed in air. The current I is flowing through the coil of larger radius. The mutual inductance between the coils is given by ( μο = permeability of free space) ______.
The mutual inductance between a primary and secondary circuit is 0.4 H and the resistance in these circuits are \[20\Omega\] and \[4\Omega\] respectively. To produce a current of 0.5 A in the secondary, current in the primary must be changed at the rate of ______.
The value of mutual inductance of two coils is 6 mH. The current in one of the coil changes from 6 A to 1 A in 0.2 second so that e.m.f. is induced in the other coil. If the resistance of the coil is 6 Ω, the value of induced charge passing through the coil is ______.
