Advertisements
Advertisements
प्रश्न
State three factors on which the heat produced by an electric current depends. How does it depend on these factors?
Advertisements
उत्तर
The heat produced by an electric current depends on the square of the current, the resistance of the device and the time for which the current is passed through the device, i.e.:
H = I2Rt
APPEARS IN
संबंधित प्रश्न
Which instrument is used to measure electric current? How should it be connected in a circuit?
If the current through a floodlamp is 5 A, what charge passed in 10 seconds?
(a) 0.5 C
(b) 2 C
(c) 5 C
(d) 50 C
Ten bulbs are connected in a series circuit to a power supply line. Ten identical bulbs are connected in a parallel circuit to an identical power supply line.
(c) In which circuit, if one bulb blows out, all other will stop glowing?
Name two effects produced by electric current.
A given wire of resistance 1 Ω is stretched to double its length. What will be its new resistance?
Calculate the effective resistance between the points A and B in the network shown below in Figure 8.45

Find the effective resistance in the following circuit diagrams (Fig.):

Tick (✓) the correct choice among the following :
(a) A strong short bar magnet is dropped into a solenoid connected to a
galvanometer as shown in fig . The galvanometer shows a deflection to the left when the current in the coil as seen from above is counter clockwise. Which one of the following shows the correct deflection of the galvanometer when the magnet is at posi tions A, Band C.
Tick (✓) the correct choice among the following :
There are 500 turns and 2000 turns in the primary and secondary coil of a
transformer respectively. If th e output voltage is 1000 V, how large is the
input voltage?
1 kWh = `(1 "volt" xx 1 "ampere" xx "_________")/1000`
Study the following circuit and find out:
(i) Current in 12 Ω resistor.
(ii) The difference in the readings of A1 and A2, if any.

State the conditions for the flow of charge in a circuit from one point to the other.
Small amounts of electrical current are measured in milliampere (mA). How many milliampere are there in 0.25 A ?
Kilowatt hour is the unit of
One unit of electrical energy consumed is equal to 1000 kilowatt-hour.
Coulomb is the SI unit of ____________.
The flow of electric charge per unit time is called potential difference.
