English
Karnataka Board PUCPUC Science Class 11

A Transverse Wave Described by Y = ( 0 ⋅ 02 M ) Sin ( 1 ⋅ 0 M − 1 ) X + ( 30 S − 1 ) T Propagates on a Stretched String Having a Linear Mass Density of

Advertisements
Advertisements

Question

A transverse wave described by \[y = \left( 0 \cdot 02  m \right)  \sin  \left( 1 \cdot 0  m^{- 1} \right)  x + \left( 30  s^{- 1} \right)t\] propagates on a stretched string having a linear mass density of \[1 \cdot 2 \times  {10}^{- 4}   kg   m^{- 1}\] the tension in the string.

Sum
Advertisements

Solution

Given,
Wave equation,
\[y = \left( 0 \cdot 02  m \right)\sin\left( 1 \cdot 0  m^{- 1} \right)x + \left( 30  s^{- 1} \right)t\]
Let:
\[\text{ Mass  per  unit  length,   m = 1 . 2 \times  {10}^{- 4}   kg/m }\]
From  the  wave  equation,   we  have:
\[k = 1   m^{- 1}  = \frac{2\pi}{\lambda}\]
And,
\[\omega = 30   s^{- 1}  = 2\pi f\]
Velocity of the wave in the stretched string is given by
\[\nu = \lambda f = \frac{\omega}{k} = \frac{30}{1}\]
\[ \Rightarrow v = 30  m/s\]
We  know:
\[v = \sqrt{\frac{T}{m}}\]
\[ \Rightarrow 30   = \sqrt{\left( \frac{T}{1 . 2 \times {10}^{- 4}} \right)}\]
\[ \Rightarrow T = 108 \times  {10}^{- 3}  = 0 . 108  N\]
So, the tension in the string is 0.108 N.

shaalaa.com
  Is there an error in this question or solution?
Chapter 15: Wave Motion and Waves on a String - Exercise [Page 324]

APPEARS IN

HC Verma Concepts of Physics Volume 1 and 2 [English]
Chapter 15 Wave Motion and Waves on a String
Exercise | Q 18 | Page 324

RELATED QUESTIONS

When a transverse wave on a string is reflected from the free end, the phase change produced is ..............

(a) zero rad

(b) ` pi/2 ` rad

(c) `(3pi)/4` rad

(d) `pi`  rad


A wire of density ‘ρ’ and Young’s modulus ‘Y’ is stretched between two rigid supports separated by a distance ‘L’ under tension ‘T’. Derive an expression for its frequency in fundamental mode. Hence show that `n=1/(2L)sqrt((Yl)/(rhoL))` where symbols have their usual meanings


Given below are some functions of x and t to represent the displacement (transverse or longitudinal) of an elastic wave. State which of these represent (i) a traveling wave, (ii) a stationary wave or (iii) none at all:

y = cos x sin t + cos 2x sin 2t


Explain why (or how): Bats can ascertain distances, directions, nature, and sizes of the obstacles without any “eyes”,


Explain why (or how) Solids can support both longitudinal and transverse waves, but only longitudinal waves can propagate in gases


A transverse wave is produced on a stretched string 0.9 m long and fixed at its ends. Find the speed of the transverse wave, when the string vibrates while emitting the second overtone of frequency 324 Hz.


A mechanical wave propagates in a medium along the X-axis. The particles of the medium
(a) must move on the X-axis
(b) must move on the Y-axis
(c) may move on the X-axis
(d) may move on the Y-axis.


Longitudinal waves cannot


A particle on a stretched string supporting a travelling wave, takes 5⋅0 ms to move from its mean position to the extreme position. The distance between two consecutive particles, which are at their mean positions, is 2⋅0 cm. Find the frequency, the wavelength and the wave speed.


A steel wire of length 64 cm weighs 5 g. If it is stretched by a force of 8 N, what would be the speed of a transverse wave passing on it?


Consider the following statements about sound passing through a gas.
(A) The pressure of the gas at a point oscillates in time.
(B) The position of a small layer of the gas oscillates in time.


In the arrangement shown in figure  , the string has a mass of 4⋅5 g. How much time will it take for a transverse disturbance produced at the floor to reach the pulley? Take g = 10 m s−2.


A circular loop of string rotates about its axis on a frictionless horizontal place at a uniform rate so that the tangential speed of any particle of the string is ν.  If a small transverse disturbance is produced at a point of the loop, with what speed (relative to the string) will this disturbance travel on the string?


A transverse wave of amplitude 0⋅50 mm and frequency 100 Hz is produced on a wire stretched to a tension of 100 N. If the wave speed is 100 m s−1, what average power is the source transmitting to the wire?


If the speed of a transverse wave on a stretched string of length 1 m is 60 m−1, what is the fundamental frequency of vibration?


A steel wire of mass 4⋅0 g and length 80 cm is fixed at the two ends. The tension in the wire is 50 N. Find the frequency and wavelength of the fourth harmonic of the fundamental.


A 660 Hz tuning fork sets up vibration in a string clamped at both ends. The wave speed for a transverse wave on this string is 220 m s−1 and the string vibrates in three loops. (a) Find the length of the string. (b) If the maximum amplitude of a particle is 0⋅5 cm, write a suitable equation describing the motion.


Three resonant frequencies of a string are 90, 150 and 210 Hz. (a) Find the highest possible fundamental frequency of vibration of this string. (b) Which harmonics of the fundamental are the given frequencies? (c) Which overtones are these frequencies? (d) If the length of the string is 80 cm, what would be the speed of a transverse wave on this string?


Given below are some functions of x and t to represent the displacement (transverse or longitudinal) of an elastic wave. State which of these represent (i) a traveling wave, (ii) a stationary wave or (iii) none at all:

y = 3 sin (5x – 0.5t) + 4 cos (5x – 0.5t)


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×