Advertisements
Advertisements
प्रश्न
The equivalent resistance of a parallel combination of two resistors of 30 Ω and 60 Ω is ______________.
पर्याय
90 Ω
2 Ω
20 Ω
1800 Ω
Advertisements
उत्तर
The equivalent resistance of a parallel combination of two resistors of 30 Ω and 60 Ω is 20 Ω.
APPEARS IN
संबंधित प्रश्न
Differentiate between resistances in series and parallel.
Complete the following :-
(b)
State the law of combination of resistances in parallel.
A wire that has resistance R is cut into two equal pieces. The two parts are joined in parallel. What is the resistance of the combination?
Find the current in each resistor in the circuit shown below:
A 4 Ω coil and a 2 Ω coil are connected in parallel. What is their combined resistance? A total current of 3 A passes through the coils. What current passes through the 2 Ω coil?
In the diagram shown below, the cell and the ammeter both have negligible resistance. The resistor are identical.
A wire of resistance R1 is cut into five equal pieces. These five pieces of wire are then connected in parallel. If the resultant resistance of this combination be R2, then the ratio `R_1/R_2` is:
(a) `1/25`
(b)1/5
(c)5
(c)25
Show with the help of diagrams, how you would connect three resistors each of resistance 6 Ω, so that the combination has resistance of (i) 9 Ω (ii) 4 Ω.
A combination consists of three resistors in series. Four similar sets are connected in parallel. If the resistance of each resistor is 2 ohm, find the resistance of the combination.
What is the equivalent resistance of 5 equal resistors, each of value 2`Omega` 1 when oonnected in (a) Series ( b) ParaIleI?
Two resistors of resistance 4 Ω and 6 Ω are connected in parallel to a cell to draw 0.5 A current from the cell.
Draw a labeled diagram of the arrangement
Solve the following question:
In an electric circuit, two resistors of 12 0 each are joined in parallel to a 6 V battery. Find the current drawn from the battery.
How does the resistance of a metallic wire depend on the length of wire?
How does the resistance of a metallic wire depend on the thickness of wire?
Two V-I graphs A and B for series and parallel combinations of two resistors are as shown. Giving reason state which graph shows (a) series, (b) parallel combination of the resistors.
