Advertisements
Advertisements
Question
What is nichrome? State its one use.
Advertisements
Solution
Nichrome is an alloy of nickel, chromium, manganese and iron. It is used to make the heating elements of electrical appliances because it has a high resistance and a high melting point.
APPEARS IN
RELATED QUESTIONS
Name any two effects of electric current.
Give two reasons why nichrome alloy is used for making the heating elements of electrical appliances.
An electric kettle rated at 220 V, 2.2 kW, works for 3 hours. Find the energy consumed and the current drawn.
An electric iron of resistance 20 ohms draws a current of 5 amperes. Calculate the heat produced in 30 seconds.
A heating coil has a resistance of 200 Ω. At what rate will heat be produced in it when a current of 2.5 A flows through it?
Which of the following characteristic is not suitable for a fuse wire?
(a) thin and short
(b) thick and short
(c) low melting point
(d) higher resistance than rest of wiring
Three heaters each rated 250 W, 100 V are connected in parallel to a 100 V supply. Calculate:
- the total current taken from the supply
- the resistance of each heater and
- the energy supplied in kWh to the three heaters in 5 hours.
Name any six domestic appliances based on the heating effect of electric current.
A coil of an alloy _______ is used in electric heater cooker as a resistor.
Find the odd one out and give its explanation.
Live wire and neutral wires have a 220 V potential difference.
How can overloading be avoided?
Define fuse.
An electric bulb is connected to a 220 V generator. The current is 0.50 A. What is the power of the bulb?
What is Joule’s heating effect? How can it be demonstrated experimentally? List its four applications in daily life.
An electric component used as a safety device is electric circuit is ______.
The following is not a safety device.
Two students decided to investigate the effect of water and air on iron object under identical experimental conditions. They measured the mass of each object before placing it partially immersed in 10 ml of water. After a few days, the object were removed, dried and their masses were measured. The table shows their results.
| Student | Object | Mass of Object before Rusting in g |
Mass of the coated object in g |
| A | Nail | 3.0 | 3.15 |
| B | Thin plate | 6.0 | 6.33 |
What might be the reason for the varied observations of the two students?
In a set up the students coated iron nails with zinc metal and noted that, iron nails coated with zinc prevents rusting. They also observed that zinc initially acts as a physical barrier, but an extra advantage of using zinc is that it continues to prevent rusting even if the layer of zinc is damaged. Name this process of rust prevention and give any two other methods to prevent rusting.
State the law that explains the heating effect of current with respect to the measurable properties in an electrical circuit.
