English

Name the Part of the Vernier Callipers Which is Used to Measure the Following External Diameter of a Tube

Advertisements

Question

Name the part of the vernier callipers which is used to measure the following

External diameter of a tube

One Line Answer
Advertisements

Solution

Outside jaws

shaalaa.com
  Is there an error in this question or solution?
Chapter 1: Measurements and Experimentation - Exercise 1 (B) [Page 20]

APPEARS IN

Selina Concise Physics [English] Class 9 ICSE
Chapter 1 Measurements and Experimentation
Exercise 1 (B) | Q 13.1 | Page 20

RELATED QUESTIONS

The wavelength of light is 589 nm. what is its wavelength in Å?


While measuring the length of a rod with a vernier callipers, below shows the position of its scales. What is the length of the rod? 


Define metre in terms of the wavelength of light.


Figure shows the position of vernier scale while measuring the external length of a wooden cylinder.

  1. What is the length recorded by the main scale?
  2. Which reading of vernier scale coincides with the main scale?
  3. Calculate the length.

(a) A vernier scale has 20 divisions. It slides over the main scale, whose pitch is 0.5 mm. If the number of divisions on the left hand of the zero of vernier on the main scale is 38 and the 18th vernier scale division coincides with the main scale, calculate the diameter of the sphere, held in the jaws of vernier callipers.
(b) If the vernier has a negative error of 0.04 cm, calculate the corrected radius of the sphere.


State the formula for calculating length if:

Number of vernier scale division coinciding with the main scale and number of division of main scale on the left-hand side of zero of vernier scale is known.


A micrometre screw gauge has a negative zero error of 8 divisions. While measuring the diameter of a wire the reading on the main scale is 3 divisions and the 24th circular scale division coincides with baseline.
If the number of divisions on the main scale are 20 to a centimetre and circular scale has 50 divisions, calculate

  1. pitch
  2. observed diameter.
  3. least count
  4. corrected diameter.

What is the least count in the case of the following instrument?

Thermometer


Name the material used for making a screw gauge.

Define the pitch of the screw gauge.

Advertisements
Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×