Advertisements
Advertisements
प्रश्न
Write any two characteristics of a series combination of resistors.
Advertisements
उत्तर
Characteristics of series combination of resistors:-
- The same current flows through each resistor.
- The voltage (potential difference) across the combination is equal to the sum of the voltage drops across the individual resistors.
- The effective resistance of the combination is equal to the sum of the individual resistances.
- The effective resistance of the combination is greater than any of the individual resistances.
- The voltage across each resistor is directly proportional to the resistance of the resistor.
- The series combination can be used to increase the resistance in a circuit.
APPEARS IN
संबंधित प्रश्न
How does the resistance of a wire change when:
its diameter is tripled?
The diagram below shows part of a circuit:
If this arrangement of three resistors was to be replaced by a single resistor, its resistance should be:
(a) 9 Ω
(b) 4 Ω
(c) 6 Ω
(d) 18 Ω
State how are the two resistors joined with a battery when same current flows in each resistor.
In series combination of resistances ______.
A graph is plotted taking p.d. along y-axis and electric current along x-axis. Name the physical quantity that represents the slope of this graph (Fig.).
You have three resistors of values 2 `Omega`, 3 `Omega`, and 5 `Omega`. How will you join them so that the total resistance is less than 2 `Omega`?
Answer the following question.
While studying the dependence of potential difference ( V) across a resistor on the current (I) passing through it, in order to determine the resistance of the resistor, a student took 5 readings for different values of current and plotted a graph between V and t. He got a straight line graph passing through the origin. What does the straight-line signify? Write the method of determining the resistance of the resister using this graph.
Bends in a rubber pipe reduce the flow of water through it. How would the bands in a wire affect its electric resistance?
The voltage applied to a given rheostat is made four times its initial value. By what factor will be resistance of the rheostat change?
Write an expression for calculating electrical power in terms of current and resistance.
State and explain the laws of resistance.
Two lamps of resistance 30Ω and 20Ω respectively are connected in series in a 110V circuit. Calculate:
(i) the total resistance in the circuit
(ii) the current in the circuit, and
(iii) the voltage drop across each lamp.
Two resistors of 4Ω and 6Ω are connected in parallel to a cell to draw 0.5 A current from the cell. Calculate the current in each resistor.
What should be the length of a nickel wire of area of cross-section 3 mm2 used for making a rheostat of 750 ohm? (ρ of nickle = 0.069 Ohm mm2/m)
A metal wire of resistance 6 Ω is stretched so that its length is increased to twice its original length. Calculate its new resistance.
Two resistors having 2Ω and 3Ω resistance are connected—(i) in series, and (ii) in parallel. Find the equivalent resistance in each case.
What is the maximum resistance which can be made using five resistors each of `1/5` W?
If the current I through a resistor is increased by 100% (assume that temperature remains unchanged), the increase in power dissipated will be:
Show how you would connect three resistors, each of resistance 6 Ω, so that the combination has a resistance of 4 Ω.
