Advertisements
Advertisements
प्रश्न
You are supplied with a number of 100 Ω resistors. How could you combine some of these resistors to make a 250 Ω resistor?
Advertisements
उत्तर
When two 100 Ω resistors are connected in parallel, the value of the combined resistance becomes 50 Ω.
Now to get a resistance of 250 Ω, we must connect two more 100 Ω resistors in series with the above combination.
Therefore, the configuration will be two 100 Ω resistors in series with a parallel combination of another two 100 Ω resistors.
APPEARS IN
संबंधित प्रश्न
Judge the equivalent resistance when the following are connected in parallel − (a) 1 Ω and 106Ω, (b) 1 Ω and 103Ω and 106Ω.
Write down an expression for the resistance of a metallic wire in terms of the resistivity.
Give one example to show how the resistance depends on the nature of material of the conductor.
If five resistances, each of value 0.2 ohm, are connected in series, what will be the resultant resistance?
Two resistances X and Y are connected turn by turn:
- in parallel, and
- in series.
In which case the resultant resistance will be less than either of the individual resistances?
What possible values of resultant resistance one can get by combining two resistances, one of value 2 ohm and the other 6 ohm?
What is (a) highest, and (b)Ω lowest, resistance which can be obtained by combining four resistors having the following resistances?
4 Ω, 8 Ω, 12 Ω, 24 Ω
What is the resistance between A and B in the figure given below?
Calculate the equivalent resistance of the following combination of resistor r1, r2, r3, and r4
When do you say that the resistors are connected in this way? Draw a circuit diagram.
Define the term resistivity and state its S.I. unit. Which will have higher resistivity a conductor or an insulator.
State expression for Resistance connected in series.
Two lamps of resistance 30Ω and 20Ω respectively are connected in series in a 110V circuit. Calculate:
(i) the total resistance in the circuit
(ii) the current in the circuit, and
(iii) the voltage drop across each lamp.
Two wires of same material and same lengths have radii in the ratio of 2 : 3, Compare their resistances.
Two resistors having 2Ω and 3Ω resistance are connected—(i) in series, and (ii) in parallel. Find the equivalent resistance in each case.
If R1 and R2 be the resistance of the filament of 40 W and 60 W respectively operating 220 V, then:
The resistance of the hot filament of the bulb is about 10 times the cold resistance. What will be the resistance of 100 W-220 V lamps, when not in use?
When a 4 Ω resistor is connected across the terminals of a 2 V battery, the number of coulombs passing through the resistor per second is:
