हिंदी

The Diagram Below Shows Part of a Circuit: - Science

Advertisements
Advertisements

प्रश्न

The diagram below shows part of a circuit: 

 

If this arrangement of three resistors was to be replaced by a single resistor, its resistance should be:
 
(a) 9 Ω
(b) 4 Ω
(c) 6 Ω
(d) 18 Ω

Advertisements

उत्तर

 (a) 9 Ώ
The two resistors of 6 Ώ are connected in parallel with each other. So, their net resistance 3 Ώ is connected in series with a resistance of 6 Ώ. So, the net resistance of the complete arrangement is 9 Ω.

shaalaa.com
  क्या इस प्रश्न या उत्तर में कोई त्रुटि है?
अध्याय 1: Electricity - Exercise 5

APPEARS IN

लखमीर सिंग Physics (Science) [English] Class 10
अध्याय 1 Electricity
Exercise 5 | Q 38

संबंधित प्रश्न

In series combination which remains constant?
(a) Voltage
(b) Current
(c) Both current and voltage
(d) Both are variables


A piece of wire of resistance R is cut into five equal parts. These parts are then connected in parallel. If the equivalent resistance of this combination is R’, then the ratio `"R"/"R'"` is ______.


Why is the series arrangement not used for domestic circuits?


Calculate the combined resistance in each case: 


You are supplied with a number of 100 Ω resistors. How could you combine some of these resistors to make a 250 Ω resistor?


What is electrical resistance? Write its SI unit.

What do you mean by an equivalent resistance?

Name the following substances:
(i) Showing low resistivity,
(ii) Showing very high resistivity,
(iii) Showing moderate resistivity.


What do you mean by power rating of an electrical appliance? How do you use it to calculate 

(a) the resistance of the appliance and

(b) the safe limit of the current in it, while in use?


To increase the effective resistance in a circuit, the resistors are connected in _______________ .


A given metallic wire of resistance R is doubled on itself. What will be its new resistance?


What material is used for making wire to prepare heating coils? Give a reason.


Why are thick copper wires used as connecting wires?


State a relation between electrical power, resistance and potential difference in an electrical circuit.


In the circuit shown below, calculate the equivalent resistance between the points (i) A and B, (ii) C and D.


Illustrate-combination of cells e.g., three cells, in parallel, explaining the combination briefly. Obtain an expression for current ‘i’ in the combination.


Two resistors of 4Ω and 6Ω are connected in parallel to a cell to draw 0.5 A current from the cell.
Draw a labelled circuit diagram showing the above arrangement.


Two wires of same material and same lengths have radii in the ratio of 2 : 3, Compare their resistances.


Consider the following combinations of resistors:






  1. The combinations having equivalent resistance 1 Q is/are ______.

Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×