English
Karnataka Board PUCPUC Science Class 11

When a Block a Mass M is Suspended by a Long Wire of Length L, the Elastic Potential Potential Energy Stored in the Wire is 1 2 × Stress × Strain × Volume.

Advertisements
Advertisements

Question

When a block a mass M is suspended by a long wire of length L, the elastic potential potential energy stored in the wire is `1/2`  × stress × strain × volume. Show that it is equal to `1/2`  Mgl, where l is the extension. The loss in gravitational potential energy of the mass earth system is Mgl. Where does the remaining `1/2` Mgl energy go ? 

Short/Brief Note
Advertisements

Solution

Let the CSA of the wire be A. 

\[\text{ Stress }= \frac{\text{ Force }}{\text{ Area }} = \frac{\text{ Mg }}{\text{ A }}\]
\[\text{ Strain }= \frac{\text{l}}{\text{L}}\]
\[\text{ Volume = AL} \]
\[ \text{ We need to calculate the elastic potential energy stored in the wire which is given to be equal to }\frac{1}{2} \times \text{ Stress } \times \text{ Strain } \times \text{ Volume } . \]
\[\text{ Elastic potential energy }= \frac{1}{2} \times \text{ Stress }\times \text{ Strain } \times \text{ Volume }\]
\[ = \frac{1}{2} \times \frac{Mg}{A} \times \frac{l}{L} \times AL\]
\[ = \frac{1}{2}Mgl\]

The other  \[\frac{1}{2}Mgl\]  is converted into kinetic energy of the mass. 

When the mass leaves its initial point on the spring, it acquires a velocity as it moves down. The velocity reaches its maximum at the end point. The spring oscillates. Finally, when the kinetic energy is dissipated into heat, the spring comes to rest.

shaalaa.com
  Is there an error in this question or solution?
Chapter 14: Some Mechanical Properties of Matter - Short Answers [Page 297]

APPEARS IN

HC Verma Concepts of Physics Volume 1 and 2 [English]
Chapter 14 Some Mechanical Properties of Matter
Short Answers | Q 2 | Page 297

RELATED QUESTIONS

A rod of length 1.05 m having negligible mass is supported at its ends by two wires of steel (wire A) and aluminium (wire B) of equal lengths as shown in Figure. The cross-sectional areas of wires A and B are 1.0 mm2 and 2.0 mm2, respectively. At what point along the rod should a mass be suspended in order to produce (a) equal stresses and (b) equal strains in both steel and aluminium wires.

 


A mild steel wire of length 1.0 m and cross-sectional area 0.50 × 10–2 cmis stretched, well within its elastic limit, horizontally between two pillars. A mass of 100 g is suspended from the mid-point of the wire. Calculate the depression at the midpoint.


The ratio stress/strain remain constant for small deformation of a metal wire. When the deformation is made larger, will this ratio increase or decrease?


A steel blade placed gently on the surface of water floats on it. If the same blade is kept well inside the water, it sinks. Explain.


When some wax is rubbed on a cloth, it becomes waterproof. Explain.


A rope 1 cm in diameter breaks if the tension in it exceeds 500 N. The maximum tension that may be given to a similar rope of diameter 2 cm is


The breaking stress of a wire depends on


A wire can sustain the weight of 20 kg before breaking. If the wire is cut into two equal parts, each part can sustain a weight of 


When a metal wire is stretched by a load, the fractional change in its volume ∆V/V is proportional to


Answer in one sentence.

Define strain.


A rod has a radius of 100 mm and a length of 10 cm. A 100 N force compress along its length. Calculate the longitudinal stress developed in the rod.


Modulus of rigidity of ideal liquids is ______.


Modulus of rigidity of ideal liquids is ______.


Consider two cylindrical rods of identical dimensions, one of rubber and the other of steel. Both the rods are fixed rigidly at one end to the roof. A mass M is attached to each of the free ends at the centre of the rods.


If 'S' is stress and 'Y' is young's modulus of the material of a wire, the energy stored in the wire per unit volume is ______.


What are the dimensions of stress?


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×