Advertisements
Advertisements
Question
Give three examples for leavers of the third order.
Advertisements
Solution
Levers of third order:
(i) Cutting bread with a knife.
(ii) A boy writing on a piece of paper
(iii) Forceps
(iv) A fishing rod.
RELATED QUESTIONS
Which class of lever will always have MA > 1 and why?
Name a machine to obtain gain in speed ?
Give one example of a class I lever where mechanical advantage is more than one ?
A man uses a crowbar of length 1.5 m to raise a load of 75 kgf by putting a sharp edge below the bar at a distance 1 m from his hand.
- Draw a diagram of the arrangement showing the fulcrum (F), load (L) and effort (E) with their directions.
- State the kind of lever.
- Calculate:
- load arm,
- effort arm,
- mechanical advantage and
- the effort needed.
A lever of length 9 cm has its load arm 5 cm long and the effort arm is 9 cm long.
- To which class does it belong?
- Draw a diagram of the lever showing the position of fulcrum F and directions of both the load L and effort E.
- What is the mechanical advantage and velocity ratio if the efficiency is 100%?
- What will be the mechanical advantage and velocity ratio if the efficiency becomes 50%?
The following belong to which class of lever?
Human-arm
The following belong to which class of lever?
A fire tongs
The following belong to which class of lever?
Knife
Shears, used for cutting metals and scissors used for cutting clothes are both examples of levers of the first order. However, whereas the shears always have short blades and long handles, the scissors often have blades much longer than the handles. Explain, why this is so?
The diagram shows the use of a lever.
- State the principle of moments as applied to the above lever.
- Which class of lever is this? Give an example of this class of lever.
- If FA = 100 cm, AB = 90 cm, calculate the minimum effort required to lift the load.
