Advertisements
Advertisements
प्रश्न
Consider the reaction:
\[\ce{Cr2O^{2-}_7 + 14H+ + 6e- -> 2Cr^{3+} + 7H2O}\]
What is the quantity of electricity in coulombs needed to reduce 1 mol of \[\ce{Cr2O^{2-}_7}\]?
Advertisements
उत्तर
According to the given reaction,
\[\ce{Cr2O^{2-}_7}\] One mole of ions requires 6 moles of electrons.
∴ F = 6 × 96500 C
= 579000 C
∴ The 579000 C of electricity is required to reduce 1 mol of \[\ce{Cr2O^{2-}_7}\].
APPEARS IN
संबंधित प्रश्न
The charge of how many coulomb is required to deposit 1.0 g of sodium metal (molar mass 23.0 g mol-1) from sodium ions is -
- 2098
- 96500
- 193000
- 4196
Write any four applications of electrochemical series
Following reactions occur at cathode during the electrolysis of aqueous sodium chloride solution:
Na+(aq) + e− ⟶ Na (s) E0 = 2.71 V
H+(aq) + e− ⟶ `1/2` H2 (g) E0 = 0.00 V
On the basis of their standard reduction electrode potential (E0) values, which reaction is feasible at the cathode and why?
If a current of 0.5 ampere flows through a metallic wire for 2 hours, then how many electrons would flow through the wire?
How much charge is required for the following reduction?
1 mol of Al3+ to Al.
How much charge is required for the following reduction?
1 mol of Cu2+ to Cu.
How much charge is required for the following reduction?
1 mol of \[\ce{MnO^-_4}\] to Mn2+.
A solution of Ni(NO3)2 is electrolysed between platinum electrodes using a current of 5 amperes for 20 minutes. What mass of Ni is deposited at the cathode?
On passing 1.5 F charge, the number of moles of aluminium deposited at cathode are _______ [Molar mass of Al = 27 gram mol–1]
(A) 1.0
(B) 13.5
(C) 0.50
(D) 0.75
Draw neat labelled diagram of electrolytic refining of blister copper
Following reactions occur at cathode during the electrolysis of aqueous copper(II) chloride solution :
On the basis of their standard reduction electrode potential (E°) values, which reaction is feasible at the cathode and why ?
Solve the following question.
A steady current of 2 amperes was passed through two electrolytic cells X and Y connected in series containing electrolytes FeSO4 and ZnSO4 until 2.8 g of Fe deposited at the cathode of cell X. How long did the current flow? Calculate the mass of Zn deposited at the cathode of cell Y.
(Molar mass : Fe = 56 g mol–1, Zn = 65.3 g mol–1, 1F = 96500 C mol–1)
Electrolytic cell uses electrical energy to bring about ____________.
According to Faraday’s First Law of Electrolysis, the amount of chemical reaction which occurs at any electrode during electrolysis by a current is proportional to the ____________.
What will happen during the electrolysis of aqueous solution of CuSO4 in the presence of Cu electrodes?
(i) Copper will deposit at cathode.
(ii) Copper will dissolve at anode.
(iii) Oxygen will be released at anode.
(iv) Copper will deposit at anode.
Given `1/a` = 0.5 CM–1, R = 50 ohm, N = 1.0 then equivalent conductance of electrolytic cell is
Assertion (A): During electrolysis of aqueous copper sulphate solution using copper electrodes hydrogen gas is released at the cathode.
Reason (R): The electrode potential of Cu2+/Cu is greater than that of H+/H2.
Select the most appropriate answer from the options given below:
How much electricity in terms of Faraday is required to produce 40.0 g of Al from molten Al2O3?
(Given: Molar mass of Aluminium is 27 g mol−1.)
