Advertisements
Advertisements
प्रश्न
How much charge is required for the following reduction?
1 mol of Al3+ to Al.
Advertisements
उत्तर
The given reaction is:
\[\ce{\underset{(1 mol)}{Al^{3+}} + \underset{(3 mol)}{3e-} -> Al}\]
∴ 3 moles of electrons are needed for the reduction of 1 mole of Al3+ to Al.
3 mole electrons = 3 Faradays
= 3 × 96500 C
= 2.895 × 105 C
APPEARS IN
संबंधित प्रश्न
96500 coulombs correspond to the charge on how many electrons?
How much electricity in terms of Faraday is required to produce 20 g of Ca from molten CaCl2?
(Given: Molar mass of Calcium is 40 g mol−1.)
Suggest a list of metals that are extracted electrolytically.
Three electrolytic cells A, B, C containing solutions of ZnSO4, AgNO3 and CuSO4, respectively, are connected in series. A steady current of 1.5 amperes was passed through them until 1.45 g of silver deposited at the cathode of cell B. How long did the current flow? What mass of copper and zinc were deposited?
Write any two uses of H2SO4
What is the ratio of volumes of H2 and O2 liberated during electrolysis of acidified water?
(A) 1 : 2
(B) 2 : 1
(C) 1 : 8
(D) 8 : 1
Explain Faraday’s second law of electrolysis
How many faradays of electricity are required to produce 13 gram of aluminium from aluminium chloride solution? (Given: Molar mass of Al = 27.0-gram mol–1)
Following reactions occur at cathode during the electrolysis of aqueous copper(II) chloride solution :
On the basis of their standard reduction electrode potential (E°) values, which reaction is feasible at the cathode and why ?
How much quantity of electricity in coulomb is required to deposit 1.346 × 10-3 kg of Ag in 3.5 minutes from AgNO3 solution?
( Given: Molar mass of Ag is 108 × 10-3 kg mol-1 )
Aqueous copper sulphate solution and aqueous silver nitrate solution are electrolysed by 1 ampere current for 10 minutes in separate electrolytic cells. Will the mass of copper and silver deposited on the cathode be same or different? Explain your answer.
Assertion: Electrolysis of NaCl solution gives chlorine at anode instead of O2.
Reason: Formation of oxygen at anode requires overvoltage.
Consider the figure and answer the following question.
Cell ‘A’ has ECell = 2V and Cell ‘B’ has ECell = 1.1V which of the two cells ‘A’ or ‘B’ will act as an electrolytic cell. Which electrode reactions will occur in this cell?
Time Required to deposite one millimole of aluminium metal by the passage of 9.65 ampere through aqueous solution of aluminium is
What is the quantity of electricity in Coulombs required to produce 4.8 g of Mg from molten MgCl2? How much Ca will be produced if the same amount of electricity was passed through molten CaCl2? (Atomic mass of Mg = 24 u, atomic mass of Ca = 40 u).
On passing electricity through nitrobenzene solution, it is converted into azobenzene. The mass of azobenzene is ______ mg, if the same quantity of electricity produces oxygen just sufficient to burn 96 mg of fullerene (C60)·
Assertion (A): During electrolysis of aqueous copper sulphate solution using copper electrodes hydrogen gas is released at the cathode.
Reason (R): The electrode potential of Cu2+/Cu is greater than that of H+/H2.
Select the most appropriate answer from the options given below:
