Advertisements
Advertisements
प्रश्न
What will happen during the electrolysis of aqueous solution of \[\ce{CuSO4}\] by using platinum electrodes?
(i) Copper will deposit at cathode.
(ii) Copper will deposit at anode.
(iii) Oxygen will be released at anode.
(iv) Copper will dissolve at anode.
Advertisements
उत्तर
(i) Copper will deposit at cathode.
(iii) Oxygen will be released at anode.
Explanation:
During electrolysis following reaction takes place at cathode:
\[\ce{Cu^{2+} + 2e^{-} -> Cu}\]
\[\ce{H^{-} + e^{-} -> 1/2 H_2}\]
Standard electrode potential of \[\ce{Cu^{2+}/Cu}\] is greater than \[\ce{H-/1/2 H2}\] therefore Cu will deposite at cathode.
APPEARS IN
संबंधित प्रश्न
The charge of how many coulomb is required to deposit 1.0 g of sodium metal (molar mass 23.0 g mol-1) from sodium ions is -
- 2098
- 96500
- 193000
- 4196
How much electricity in terms of Faraday is required to produce 20 g of Ca from molten CaCl2?
(Given: Molar mass of Calcium is 40 g mol−1.)
Number of faradays of electricity required to liberate 12 g of hydrogen is:
A solution of Ni(NO3)2 is electrolysed between platinum electrodes using a current of 5 amperes for 20 minutes. What mass of Ni is deposited at the cathode?
Three electrolytic cells A, B, C containing solutions of ZnSO4, AgNO3 and CuSO4, respectively, are connected in series. A steady current of 1.5 amperes was passed through them until 1.45 g of silver deposited at the cathode of cell B. How long did the current flow? What mass of copper and zinc were deposited?
Draw neat labelled diagram of electrolytic refining of blister copper
Calculate the mass of Ag deposited at cathode when a current of 2 amperes was passed through a solution of AgNO3 for 15 minutes.
(Given : Molar mass of Ag = 108 g mol−1 lF = 96500 C mol−1)
Following reactions occur at cathode during the electrolysis of aqueous copper(II) chloride solution :
On the basis of their standard reduction electrode potential (E°) values, which reaction is feasible at the cathode and why ?
Solve the following question.
A steady current of 2 amperes was passed through two electrolytic cells X and Y connected in series containing electrolytes FeSO4 and ZnSO4 until 2.8 g of Fe deposited at the cathode of cell X. How long did the current flow? Calculate the mass of Zn deposited at the cathode of cell Y.
(Molar mass : Fe = 56 g mol–1, Zn = 65.3 g mol–1, 1F = 96500 C mol–1)
In the electrolysis of aqueous sodium chloride solution which of the half cell reaction will occur at anode?
Aqueous copper sulphate solution and aqueous silver nitrate solution are electrolysed by 1 ampere current for 10 minutes in separate electrolytic cells. Will the mass of copper and silver deposited on the cathode be same or different? Explain your answer.
Assertion: Electrolysis of NaCl solution gives chlorine at anode instead of O2.
Reason: Formation of oxygen at anode requires overvoltage.
Time Required to deposite one millimole of aluminium metal by the passage of 9.65 ampere through aqueous solution of aluminium is
When during electrolysis of a solution of AgNO3, 9650 coulombs of charge pass through the electroplating bath, the mass of silver deposited on the cathode will be ______.
What is the quantity of electricity in Coulombs required to produce 4.8 g of Mg from molten MgCl2? How much Ca will be produced if the same amount of electricity was passed through molten CaCl2? (Atomic mass of Mg = 24 u, atomic mass of Ca = 40 u).
A current of 4 amp was passed for 2 hours through a solution of copper sulphate when 5.0 g of copper was deposited. The current efficiency is ______% (Cu = 63.5).
How much electricity in terms of Faraday is required to produce 40.0 g of Al from molten Al2O3?
(Given: Molar mass of Aluminium is 27 g mol−1.)
