Advertisements
Advertisements
प्रश्न
Choose the statement which is not correct in the case of an electric fuse.
विकल्प
Fuses are inserted in electric circuits of all buildings.
There is a maximum limit on the current which can safely flow through the electric circuits.
There is a minimum limit on the current which can safely flow in the electric circuits.
If a proper fuse is inserted in a circuit it will blow off if current exceeds the safe limit.
Advertisements
उत्तर
There is a minimum limit on the current which can safely flow in the electric circuits.
Explanation:
In an electric fuse, there is a maximum limit on the current that can safely flow through the circuit. If the current exceeds this limit, the fuse will blow and break the circuit, preventing damage to electrical components. However, there is no minimum limit on the current that can flow safely in the circuit. The fuse is designed to protect against excessive current, not to regulate a minimum current.
APPEARS IN
संबंधित प्रश्न
Redraw the circuit of question 1, putting in an ammeter to measure the current through the resistors and a voltmeter to measure the potential difference across the 12 Ω resistors. What would be the readings in the ammeter and the voltmeter?
Draw circuit symbols for
a battery of three cells
The following figure shows the symbols for components used in the accompanying electrical circuit. Place them at proper places and complete the circuit.
Which law can you prove with the help of above circuit?
Draw a neat diagram showing a closed electric circuit.
In the circuit diagram below, 10 units of electric charge move past point x every second What is the current in the circuit ______.
Higher Order Question
A student made a circuit by using an electric cell, a switch, a torch bulb (fitted in the bulb holder), and copper connecting wires. When he turned on the switch, the torch bulb did not glow at all. The student checked the circuit and found that all the wire connections were tight.
- What could be the possible reason for the torch bulb not glowing even when the circuit appears to be complete?
The rate of flow of electric charges in a circuit is called ______.
When an electric current flows through a copper wire AB as shown in the following figure, the wire
Name the device used these days in place of electric fuses in electrical circuits.
Name the device which is used to measure the strength of the electric current in an electric circuit.
