Advertisements
Advertisements
Question
Why a photo-diode is operated in reverse bias whereas the current in the forward bias is much larger than that in the reverse bias? Explain. Mention its two uses.
Advertisements
Solution
When a diode is reverse biassed and a small reverse current flows through it, the width of the depletion layer increases.
When light strikes the junction, a large number of electron-hole pairs are generated in the depletion layer due to the wide depletion layer. As a result, in reverse bias, the diode converts more incident light to current, i.e., photocurrent is greater in reverse bias than in forward bias.
Forward bias current is greater than reverse bias current, but the fractional change in reverse bias current is more easily measurable than the fractional change in forward bias current.
As a result, photo-diodes are used in reverse bias.
Uses: In smoke detectors, in bar code scanners.
APPEARS IN
RELATED QUESTIONS
Describe, with the help of a circuit diagram, the working of a photodiode.
Write briefly the important processes that occur during the formation of p−n junction. With the help of necessary diagrams, explain the term 'barrier potential'.
Describe briefly, with the help of a diagram, the role of the two important processes involved in the formation of a p-n junction.
Explain the formation of depletion layer and potential barrier in a p−n junction.
Explain how a potential barrier is developed in a p-n junction diode.
With reference to Semiconductor Physics,
Name the process that causes depletion region in a p-n junction.
Consider the following statements (A) and (B) and identify the correct answer.
- A Zener diode is connected in reverse bias when used as a voltage regulator.
- The potential barrier of the p-n junction lies between 0.1 V to 0.3 V.
The amplifiers X, Y and Z are connected in series. If the voltage gains of X, Y and Z are 10, 20 and 30, respectively and the input signal is 1 mV peak value, then what is the output signal voltage (peak value)
- if dc supply voltage is 10V?
- if dc supply voltage is 5V?
Read the following paragraph and answer the questions.
|
LED is a heavily doped P-N junction which under forward bias emits spontaneous radiation. When it is forward-biased, due to recombination of holes and electrons at the junction, energy is released in the form of photons. In the case of Si and Ge diode, the energy released in recombination lies in the infrared region. LEDs that can emit red, yellow, orange, green and blue light are commercially available. The semiconductor used for fabrication of visible LEDs must at least have a band gap of 1.8 eV. The compound semiconductor Gallium Arsenide – Phosphide is used for making LEDs of different colours.
|
- Why are LEDs made of compound semiconductor and not of elemental semiconductors?
- What should be the order of bandgap of an LED, if it is required to emit light in the visible range?
- A student connects the blue coloured LED as shown in the figure. The LED did not glow when switch S is closed. Explain why?
OR
iii. Draw V-I characteristic of a p-n junction diode in
(i) forward bias and (ii) reverse bias
Draw the circuit diagram of an illuminated photodiode and its I-V characteristics.
