Advertisements
Advertisements
Question
Draw a sketch of a sinusoidal carrier wave along with a modulating signal and show how these are superimposed to obtain the resultant amplitude modulated wave
Advertisements
Solution
APPEARS IN
RELATED QUESTIONS
Define modulation index.
State three important factors showing the need for translating a low frequency signal into a high frequency wave before transmission
The carrier wave is given by
C(t) = 2sin(8πt) volt.
The modulating signal is a square wave as shown. Find modulation index.
Explain the need for modulation related to the size of antenna (aerial).
In a communication system, what is meant by modulation?
The carrier wave of a signal is given by C(t) = 3 sin (8πt) volt. The modulating signal is a square wave as shown. Find its modulation index.
In the block diagram of a simple modulator for obtaining an AM signal, shown in the figure, identify the boxes A and B. Write their function.
A TV transmission tower antenna is at a height of 20 m. How much service area can it cover if the receiving antenna is (i) at ground level, (ii) at a height of 25 m? Calculate the percentage increase in area covered in case (ii) relative to case (i).
A carrier wave Vc(t) = 160 sin(2π × 106t) volts is made to vary between Vmax = 200 V and Vmin = 120 V by a message signal Vm(t) = Am sin(2π × 103t) volts. The peak voltage Am of the modulating signal is ______.
A transmitting antenna has a height of 320 m and that of receiving antenna is 2000 m. The maximum distance between them for satisfactory communication in line of sight mode is 'd'. The value of 'd' is ______ km.
