Advertisements
Advertisements
प्रश्न
Draw a sketch of a sinusoidal carrier wave along with a modulating signal and show how these are superimposed to obtain the resultant amplitude modulated wave
Advertisements
उत्तर
APPEARS IN
संबंधित प्रश्न
The process of superimposing a low frequency signal on a high frequency wave is_______ .
How are side bands produced?
What is the role of a bandpass filter?
Define the term modulation. Draw a block diagram of a simple modulator for obtaining AM signal ?
Answer the following question.
Why a signal transmitted from a TV tower cannot be received beyond a certain distance? Write the expression for the optimum separation between the receiving and the transmitting antenna.
A 20 volt AC is applied to a circuit consisting of a resistance and a coil with negligible resistance. If the voltage across the resistance is 12 volt, the voltage across the coil is ______.
A speech signal of 3 kHz is used to modulate a carrier signal of frequency 1 MHz, using amplitude modulation. The frequencies of the sidebands will be ______.
I-V characteristics of four devices are shown in Figures.
 |
 |
 |
|
| (i) | (ii) | (iii) | (iv) |
Identify devices that can be used for modulation.
An audio signal of 15kHz frequency cannot be transmitted over long distances without modulation because ______.
- the size of the required antenna would be at least 5 km which is not convenient.
- the audio signal can not be transmitted through sky waves.
- the size of the required antenna would be at least 20 km, which is not convenient.
- effective power transmitted would be very low, if the size of the antenna is less than 5 km.
A 25 m long antenna is mounted on an antenna tower. The height of the antenna tower is 75 m. The wavelength (in meter) of the signal transmitted by this antenna would be ______.
