Advertisements
Advertisements
प्रश्न
Why is the series arrangement not used for domestic circuits?
Advertisements
उत्तर
Series connections are not used in domestic electrical circuits due to the following reasons:
- It cannot be used with different devices (devices) with different switches on and off. If one equipment fails, the other also stops working.
- In series connection, the same current flows through all the devices, which we do not need.
- Due to high total resistance of the circuit (R = R1 + R2 + ...), the value of current becomes extremely low.
APPEARS IN
संबंधित प्रश्न
Judge the equivalent resistance when the following are connected in parallel − (a) 1 Ω and 106Ω, (b) 1 Ω and 103Ω and 106Ω.
The V-I graph for a series combination and for a parallel combination of two resistors is shown in the figure below. Which of the two A or B. represents the parallel combination? Give reasons for your answer.
(i) Two sets A and B, of three bulbs each, are glowing in two separate rooms. When one of the bulbs in set A is fused, the other two bulbs also cease to glow. But in set B, when one bulb fuses, the other two bulbs continue to glow. Explain why this phenomenon occurs.
(ii) Why do we prefer arrangements of Set B for house circuiting?
The substance having infinitely high electrical resistance is called:
(a) conductor
(b) resistor
(c) superconductor
(d) insulator
How does the resistance of a wire change when:
its length is tripled?
The diagram below shows part of a circuit:
If this arrangement of three resistors was to be replaced by a single resistor, its resistance should be:
(a) 9 Ω
(b) 4 Ω
(c) 6 Ω
(d) 18 Ω
State how are the two resistors joined with a battery when equivalent resistance is more than either of the two resistances.
State how are the two resistors joined with a battery when same current flows in each resistor.
How will you oonnect five resistors, each of the value one ohm, to obtain an equivalent resistance of 0.2 `Omega`
Three resistors of 6.0 Ω, 2.0 Ω and 4.0 Ω are joined to an ammeter A and a cell of emf 6.0 V as shown in the following figure. Calculate :
- the effective resistance of the circuit.
- the reading of ammeter.
What material is used for making wire to prepare heating coils? Give a reason.
How does the resistivity of an alloy such as constantace depends on temperature.
State expression for Resistance connected in parallel.
What is the equivalent resistance between the points X and Y for the given network?
Two resistors of 4Ω and 6Ω are connected in parallel to a cell to draw 0.5 A current from the cell. Calculate the current in each resistor.
What is the maximum resistance which can be made using five resistors each of `1/5` W?
