Advertisements
Advertisements
प्रश्न
Name the material which is used for making the heating element of an electric iron.
Advertisements
उत्तर
The coils of the heating element of an electric iron is made of alloys like nichrome because alloys have a high resistance and a high melting point.
APPEARS IN
संबंधित प्रश्न
A piece of wire of resistance R is cut into five equal parts. These parts are then connected in parallel. If the equivalent resistance of this combination is R’, then the ratio `"R"/"R'"` is ______.
The V-I graph for a series combination and for a parallel combination of two resistors is shown in the figure below. Which of the two A or B. represents the parallel combination? Give reasons for your answer.
Find the equivalent resistance between points A and B
What possible values of resultant resistance one can get by combining two resistances, one of value 2 ohm and the other 6 ohm?
A p.d. of 4 V is applied to two resistors of 6 Ω and 2 Ω connected in series. Calculate:
(a) the combined resistance
(b) the current flowing
(c) the p.d. across the 6 Ω resistor
State how are the two resistors joined with a battery when equivalent resistance is more than either of the two resistances.
How will you oonnect five resistors, each of the value one ohm, to obtain an equivalent resistance of 0.2 `Omega`
Calculate the equivalent resistance of the following combination of resistor r1, r2, r3, and r4
What do you mean by power rating of an electrical appliance? How do you use it to calculate
(a) the resistance of the appliance and
(b) the safe limit of the current in it, while in use?
A given metallic wire of resistance R is doubled on itself. What will be its new resistance?
How does the resistivity of a semiconductor depend on temperature?
State a relation between electrical power, resistance and potential difference in an electrical circuit.
Calculate the equivalent resistance between the points A and B for the following combination of resistors:
Calculate the equivalent resistance between P and Q from the following diagram:
Two lamps of resistance 30Ω and 20Ω respectively are connected in series in a 110V circuit. Calculate:
(i) the total resistance in the circuit
(ii) the current in the circuit, and
(iii) the voltage drop across each lamp.
Two resistors of 4Ω and 6Ω are connected in parallel to a cell to draw 0.5 A current from the cell.
Draw a labelled circuit diagram showing the above arrangement.
When a 4 Ω resistor is connected across the terminals of a 2 V battery, the number of coulombs passing through the resistor per second is:
