मराठी

An Electric Bulb is Rated as 10 W, 220 V. How Many of These Bulbs Can Be Connected in Parallel Across the Two Wires of 220 V Supply Line If the Maximum Current Which Can Be Drawn is 5 A?

Advertisements
Advertisements

प्रश्न

An electric bulb is rated as 10 W, 220 V. How many of these bulbs can be connected in parallel across the two wires of 220 V supply line if the maximum current which can be drawn is 5 A? 

Advertisements

उत्तर

Maximum power that can be drawn from the circuit = VI = 220 V x 5 A = 1100 W
Let x be the number of 10 W bulbs used.
Then the maximum power x bulbs can draw from the circuit = 1100 W
     10x = 1100 

`x=1100/10=110` buulbs

  

shaalaa.com
  या प्रश्नात किंवा उत्तरात काही त्रुटी आहे का?
पाठ 4: Electricity - Exercise 7

APPEARS IN

लखमीर सिंह Physics [English] Class 10
पाठ 4 Electricity
Exercise 7 | Q 44

व्हिडिओ ट्यूटोरियलVIEW ALL [1]

संबंधित प्रश्‍न

Fill in the blank:

To increase the effective resistance in a circuit the resistors are connected in _____________.


If the lamps are both the same in the figure given below and if A1 reads 0.50 A, what do A2, A3, A4 and A5 read? 


 Draw a circuit diagram showing two lamps, one cell and a switch connected in series.
 How can you change the brightness of the lamp?


The following table shows the current in Amperes and potential differences in Volts.

  1. Find the average resistance.
  2. What will be the nature of the graph between the current and potential difference? (Do not draw a graph.)
  3. Which law will the graph prove? Explain the law.
V (volts) I (amp)
4 9
5 11.25
6 13.5

How many electrons are present in 1 C?

Calculate the electric current supplied by a 12 V battery of an automobile to a starter that develops a power of 2.4 kW.

An electric bulb is rated at 220 V, 100 W. What is its resistance? What maximum current can be passed through it?

The following appliances are to be used on 240 V supply. Calculate the current used by each and say which fuse, 2 amp, 5 amp or 13 amp should be incorporated with each, (i) A television rated at 150 W, (ii) An electric iron rated at 750 W, (iii) An immersion heater rated at 3000 W, (iv) A hair dryer rated at 500 W. How much will it cost to run the television set for 100 days for an average of 4 hours a day at 60 paise per unit?


If a fuse contains a 5 A fuse wire and the voltage is 240 V, what is the maximum power (wattage) which may be taken from the circuit?


60 joules of heat was dissipated in a resistor when 20 C flowed for 5 s. Calculate:
(a) P.d. across the resistor,
(b) Resistance of the resistor, and
(c) Average power dissipated in the resistor.


Transformers are usually designed so that their efficiency is as close to 100% as possible. Describe two features in transformer design which help to achieve high efficiency?

Three heaters each rated 250 W, 100 V are connected in parallel to a 100 V supply. Calculate :

The total current taken from the supply


Three heaters each rated 250 W, 100 V are connected in parallel to a 100 V supply. The resistance of each heater


A bulb is connected to a battery of p.d. 4 V and internal resistance 2.5 Ω . A steady current of 0.5 A flows through the circuit. Calculate:

The resistance of the bulb


A bulb is connected to a battery of p.d. 4 V and internal resistance 2.5 Ω . A steady current of 0.5 A flows through the circuit. Calculate:

The energy dissipated in the bulb in 10 minutes.


Answer the following question.
An electric lamp of resistance 20 Ω and a conductor of resistance 4 0 are connected to a 6 V battery as shown in the circuit. Calculate: 

(a) the total resistance of the circuit,  

(b) the current through the circuit, 

(c) the potential difference across the  (i) electric lamp and (ii) conductor, and

(d) power of the lamp.


Study the following circuit and find out:
      (i) Current in 12 Ω resistor.
      (ii) The difference in the readings of A1 and A2, if any.


State the condition when it is advantageous to connect cells in parallel.


Match the following:

1. 1 mA a. series
2. 1 pA b. ohmmeter
3. Ammeter  c. 10-6 ampere
4. Electrical resistivity d. 10-3 ampere

Problems for practice:

If 3A current flows through a circuit, then convert the current in terms of a milliampere.


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×