मराठी

Give the electric current unit. - Science

Advertisements
Advertisements

प्रश्न

Give the electric current unit.

What is the SI unit of electric current.

अति संक्षिप्त उत्तर
Advertisements

उत्तर

The standard SI unit for current is the ampere with the symbol A.

shaalaa.com
  या प्रश्नात किंवा उत्तरात काही त्रुटी आहे का?
पाठ 4: Electric charge and Electric current - Exercise [पृष्ठ ५०]

APPEARS IN

सामाचीर कलवी Science [English] Class 9 TN Board
पाठ 4 Electric charge and Electric current
Exercise | Q VI. 4. ii. | पृष्ठ ५०
लखमीर सिंह Physics (Science) [English] Class 10
पाठ 1 Electricity
Exercise 2 | Q 26.1 ii.

व्हिडिओ ट्यूटोरियलVIEW ALL [1]

संबंधित प्रश्‍न

Draw the electrical symbols of the following components and state its use:

Ammeter.


The atoms of copper contain electrons and the atoms of rubber also contain electrons. Then why does copper conduct electricity but rubber does not conduct electricity?


Which of the two is connected in series : ammeter or voltmeter?


Fill in the folloing blank with suitable words:

 A current is a flow of ............... .For this to happen there must be a ............... circuit.


Which unit could be used to measure current?

(a) Watt
(b) Coulomb
(c) Volt
(d) Ampere


A battery and three lamps are connected as shown: 

 

Which of the following statements about the currents at X, Y and Z is correct?
(a) The current at Z is greater than that at Y.
(b) The current at Y is greater than that at Z.
(c) The current at X equals the current at Y.
(d) The current at X equals the current at Z. 

 


You can given one hundred 1 Ω resistors. What is the smallest and largest resistance you can make in a circuit using these?


Draw a circuit diagram showing two electric lamps connected in parallel together with a cell and a switch that works both lamps. Mark an â’¶ on your diagram to show where an ammeter should be placed to measure the current.


State the S.I. unit of current.


In the network shown in the following adjacent Figure, calculate the equivalent resistance between the points.  

  1. A and B
  2. A and C

 


If a charge of 420 C flows through a conducting wire in 5 minutes what is the value of the current?


An electric current flowing in a wire creates ______ around the wire. 


Calculate the electric current supplied by a 12 V battery of an automobile to a starter that develops a power of 2.4 kW.

An electric bulb is rated at 220 V, 100 W. What is its resistance? What maximum current can be passed through it?

Tick(✓) the correct choice in the following:

The outer casing of an electric iron is generally connected to earth in order
to


Define the following:

Semiconductors


In the circuit shown in fig. 6, find the reading of the ammeter A when the switch S is
(a) Opened.
(b) Closed.


The following appliances are to be used on 240 V supply. Calculate the current used by each and say which fuse, 2 amp, 5 amp or 13 amp should be incorporated with each, (i) A television rated at 150 W, (ii) An electric iron rated at 750 W, (iii) An immersion heater rated at 3000 W, (iv) A hair dryer rated at 500 W. How much will it cost to run the television set for 100 days for an average of 4 hours a day at 60 paise per unit?


If a fuse contains a 5 A fuse wire and the voltage is 240 V, what is the maximum power (wattage) which may be taken from the circuit?


What is meant by the term 'electromotive force' of a cell?

A 3 pin mains plug is fitted to the lead for a 1 kW electric kettle to be used on a 250 V A.C. supply. Which of the following statements is NOT correct?
(a) A 13 A fuse is the most appropriate value to use.
(b) The brown wire should be connected to the live side of the mains.


A primary of 800 turns is connected to a 220 V A.C. supply and the secondary has 8 turns. What will be the output voltage?

Fig . shows the core of a transformer and i ts input and output connections 

State the material used for the core and describe th e structure of the core.
(a) Use the values given in the diagram to calculate the turns ratio for the transformer and connections, labeling all parts of the diagram .
(b) If a current of 2 A is taken from th e output, calculate th e current in the input circuit (Assume the transformer to be ideal ).


Transformers are usually designed so that their efficiency is as close to 100% as possible. Describe two features in transformer design which help to achieve high efficiency?

State the S.I. units of electrical power.


Two electric bulbs rated 100 W; 220 V and 60 W; 220 V are connected in parallel to electric mains of 220 V. Find the current drawn by the bulbs from the mains.


The flow of electric charge per unit time is called potential difference.


What are the effects of electric current?


Assertion (A): Electric current will not flow between two charged bodies when connected if their charges are the same.
Reason (R): Current is the rate of flow of charge.


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×