हिंदी
कर्नाटक बोर्ड पी.यू.सी.पीयूसी विज्ञान कक्षा ११

Consider the Circuit Shown in Figure. (A) Find the Current Through the Battery a Long Time After the Switch S Is Closed. (B) Suppose the Switch is Again Opened At T = 0.

Advertisements
Advertisements

प्रश्न

Consider the circuit shown in figure. (a) Find the current through the battery a long time after the switch S is closed. (b) Suppose the switch is again opened at t = 0. What is the time constant of the discharging circuit? (c) Find the current through the inductor after one time constant.

योग
Advertisements

उत्तर

(a) Because the switch is closed, the battery gets connected across the L‒R circuit.

The current in the L‒R circuit after t seconds after connecting the battery is given by

i = i0 (1 − e−t)

Here,

i0 = Steady state current

τ = Time constant = `L/R`

After a long time, t → ∞.

Now,

Current in the inductor, i = i0 (1 − e0) = 0

Thus, the effect of inductance vanishes.

\[i = \frac{\epsilon}{R_{net}}\]

\[i = \frac{\epsilon}{\frac{R_1 \times R_2}{R_1 + R_2}} = \frac{\epsilon( R_1 + R_2 )}{R_1 R_2}\]


(b) When the switch is opened, the resistance are in series.

The time constant is given by

\[\tau = \frac{L}{R_{net}} = \frac{L}{R_1 + R_2}\]


(c) The inductor will discharge through resistors R1 and R2.
The current through the inductor after one time constant is given by

t = τ

∴ Current, i = i0 e−τ

Here,

\[i_0=\frac{\epsilon}{R_1 + R_2}\]

\[\therefore i=\frac{\epsilon}{R_1 + R_2} \times \frac{1}{e}\]

shaalaa.com
  क्या इस प्रश्न या उत्तर में कोई त्रुटि है?
अध्याय 38: Electromagnetic Induction - Exercises [पृष्ठ ३१३]

APPEARS IN

एचसी वर्मा Concepts of Physics Volume 1 and 2 [English]
अध्याय 38 Electromagnetic Induction
Exercises | Q 90 | पृष्ठ ३१३

संबंधित प्रश्न

(i) Find the value of the phase difference between the current and the voltage in the series LCR circuit shown below. Which one leads in phase : current or voltage ?

(ii) Without making any other change, find the value of the additional capacitor C1, to be connected in parallel with the capacitor C, in order to make the power factor of the circuit unity.


An L-R circuit has L = 1.0 H and R = 20 Ω. It is connected across an emf of 2.0 V at t = 0. Find di/dt at (a) t = 100 ms, (b) t = 200 ms and (c) t = 1.0 s.


An LR circuit contains an inductor of 500 mH, a resistor of 25.0 Ω and an emf of 5.00 V in series. Find the potential difference across the resistor at t = (a) 20.0 ms, (b) 100 ms and (c) 1.00 s.


An inductor-coil of inductance 17 mH is constructed from a copper wire of length 100 m and cross-sectional area 1 mm2. Calculate the time constant of the circuit if this inductor is joined across an ideal battery. The resistivity of copper = 1.7 × 10−8 Ω-m.


An LR circuit having a time constant of 50 ms is connected with an ideal battery of emf ε. find the time elapsed before (a) the current reaches half its maximum value, (b) the power dissipated in heat reaches half its maximum value and (c) the magnetic field energy stored in the circuit reaches half its maximum value.


A series LCR circuit with L = 0.12 H, C = 480 nF, R = 23 Ω is connected to a 230 V variable frequency supply.

(a) What is the source frequency for which current amplitude is maximum. Obtain this maximum value.

(b) What is the source frequency for which average power absorbed by the circuit is maximum. Obtain the value of this maximum power.

(c) For which frequencies of the source is the power transferred to the circuit half the power at resonant frequency? What is the current amplitude at these frequencies?

(d) What is the Q-factor of the given circuit?


Obtain the resonant frequency and Q-factor of a series LCR circuit with L = 3.0 H, C = 27 µF, and R = 7.4 Ω. It is desired to improve the sharpness of the resonance of the circuit by reducing its ‘full width at half maximum’ by a factor of 2. Suggest a suitable way.


In a series LCR circuit the voltage across an inductor, capacitor and resistor are 20 V, 20 V and 40 V respectively. The phase difference between the applied voltage and the current in the circuit is ______.


At resonance frequency the impedance in series LCR circuit is ______.


The resonant frequency of a RF oscillator is 1 MHz and its bandwidth is 10 kHz. The quality factor will be :


To reduce the resonant frequency in an LCR series circuit with a generator


In series LCR AC-circuit, the phase angle between current and voltage is


In an LCR circuit having L = 8 henery. C = 0.5 µF and R = 100 ohm in series, the resonance frequency in radian/sec is


A series LCR circuit containing 5.0 H inductor, 80 µF capacitor and 40 Ω resistor is connected to 230 V variable frequency ac source. The angular frequencies of the source at which power transferred to the circuit is half the power at the resonant angular frequency are likely to be ______.


For an LCR circuit driven at frequency ω, the equation reads

`L (di)/(dt) + Ri + q/C = v_i = v_m` sin ωt

  1. Multiply the equation by i and simplify where possible.
  2. Interpret each term physically.
  3. Cast the equation in the form of a conservation of energy statement.
  4. Integrate the equation over one cycle to find that the phase difference between v and i must be acute.

A series RL circuit with R = 10 Ω and L = `(100/pi)` mH is connected to an ac source of voltage V = 141 sin (100 πt), where V is in volts and t is in seconds. Calculate

  1. the impedance of the circuit
  2. phase angle, and
  3. the voltage drop across the inductor.

Draw the phasor diagram for a series LRC circuit connected to an AC source.


When an alternating voltage of 220V is applied across device X, a current of 0.25A flows which lags behind the applied voltage in phase by π/2 radian. If the same voltage is applied across another device Y, the same current flows but now it is in phase with the applied voltage.

  1. Name the devices X and Y.
  2. Calculate the current flowing in the circuit when the same voltage is applied across the series combination of X and Y.

Three students, X, Y and Z performed an experiment for studying the variation of ac with frequency in a series LCR circuit and obtained the graphs as shown below. They all used

  • an AC source of the same emf and
  • inductance of the same value.

  1. Who used minimum resistance?
  2. In which case will the quality Q factor be maximum?
  3. What did the students conclude about the nature of impedance at resonant frequency (f0)?
  4. An ideal capacitor is connected across 220 V, 50 Hz, and 220 V, 100 Hz supplies. Find the ratio of current flowing through it in the two cases.

Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×