Advertisements
Advertisements
Question
How is the working of an electric bell affected, if alternating current be used instead of direct current?
Advertisements
Solution
If an A.C. source is used in place of a battery, the core of the electromagnet will get magnetized, but the polarity at its ends will change. Since the attraction of the armature does not depend on the polarity of the electromagnet, the bell will still ring on pressing the switch.
RELATED QUESTIONS
Why is soft iron used as the core of the electromagnet in an electric bell?
Name one device that uses an electromagnet.
Electromagnets are made up of :
The strength of the electromagnet can be increased by
How is an electromagnet made? Name two factors on which the strength of magnetic field of the electromagnet depends.
You are required to make an electromagnet from a soft iron bar by using a cell, an insulated coil of copper wire and a switch.
- Draw a circuit diagram to represent the process.
- Label the poles of the electromagnet.
The following figure shows a coil wound around a soft iron bar XY.
- State the polarity at the ends X and Y as the switch is pressed.
- Suggest one way of increasing the strength of electromagnet so formed.
A coil of insulated copper wire is wound around a piece of soft iron and current is passed in the coil from a battery. What name is given to the device so obtained? Give one use of the device mentioned by you.
State two ways through which the strength of an electromagnet can be increased.
Name one device that uses an electromagnet.
State two advantages of an electromagnet over a permanent magnet.
Name the material used for making the armature of an electric bell. Give a reason for your answer.
Explain, why steel is used in preference to soft iron for making permanent magnets while soft iron is used in preference to steel for making electromagnets.
Explain in detail the application of electromagnets.
Unlike magnetic poles ______ whereas like poles ______.
Assertion (A): When 2 long parallel wires, hanging freely are connected in parallel to a battery, they come closer to each other.
Reason (R): Wires carrying current in opposite directions repel each other.
Explain the working of the following device.
Magnetic levitation trains.
