English
Tamil Nadu Board of Secondary EducationHSC Science Class 12

Explain the development of Mobile networks.

Advertisements
Advertisements

Question

Explain the development of Mobile networks.

Long Answer
Advertisements

Solution

The generations of mobile networks are as follows.

  1. First Generation (1G) 1981 – NMT Launch
  2. Second Generation (2G) 1991 – GSM Launch
  3. Second to Third Generation Bridge (2.5)2000 – GPRS launch
  4. Third Generation (3G) 2003 – first UK 3G launch
  5. Fourth Generation (4G) 2007
  6. Fifth Generation (5G) 2019+
  • First Generation (1G) 1981 – NMT launch:
  1. During the initial periods, the mobile systems were based on analog transmission.
  2. NMT stands for Nordic Mobile Telephone communication.
  3. And a very poor voice quality.
  • Second Generation(2G) 1991-GSM Launch:
  1. Later the second generation of mobile systems was placed on digital transmission with GSM.
  2. GSM stands for (Global System for Mobile communication) was the most popular standard which is used in the second generation, using 900MHz and 1800MHz for the frequency bands.
  3. The transfer mission used as TMDA stands for (Time Division Multiple Access) and CDMA One stands for (Code Division Multiple’Access) method to increase the amount of information transported on the network.
  • Second to Third Generation Bridge (2.5)2000 – GPRS launch:
  1. GPRS was introduced here GPRS stands for (General Packet Radio Service).
  2. GPRS is a data service which enables mobile devices to send and receive messages, picture messages, and e-mails.
  3. GSM data transfer mission rates typically reached 9.6kbit/s.
  • Third Generation( 3G) 2003- first UK 3G launch:
  1. This generation of mobile systems merges different mobile technology standards and uses higher frequency bands for transfer mission and Code Division Multiple Access to deliver data rates of up to 2Mbit/s supports multimedia services (MMS: voice, video, and data).
  2. The data transfer mission used a WCDMA. WCDMA stands for (Wideband Code Division Multiple Access).
  3. Few 3G suppliers use ATMs (Asynchronous Transfer Mode) for their ‘over the air’ network within MPLS (Multiprotocol Label Switching) or IP for their backbone network.
  • Fourth Generation (4G) 2007:
  1. 4G is at the research stage. 4G was based on an Adhoc networking model where there was no need for a fixed infrastructure operation.
  2. Adhoc networking requires global mobility features (e.g. Mobile IP) and connectivity to a global IPv6 network to support an IP address for each mobile device.
  3. Logically roaming in assorted IP networks (for example 802.11 WLAN, GPRS and UMTS) were be possible with higher data rates, from 2Mbit/s to 10-100Mbit/s, offering reduced delays and new services.
  • Fifth Generation (5G) 2019+:
  1. 5G is the stage that succeeds the 4G (LTE/ WiMAX), 3G(units), and 2G(GSM) systems.
  2. 5G targets to performance the high data rate, reduced latency, energy saving, cost reduction, higher system, capacity, and massive device connectivity.
  3. The ITU IMT – 2020 provides speeds up to 20 gigabits per second it has been demonstrated with millimeter waves of 15 gigahertz and higher frequency.
shaalaa.com
Introduction to Protocols
  Is there an error in this question or solution?
Chapter 11: Network Examples and Protocols - Evaluation - PART – IV [Page 161]

APPEARS IN

Samacheer Kalvi Computer Applications [English] Class 12 TN Board
Chapter 11 Network Examples and Protocols
Evaluation - PART – IV | Q 4. | Page 161

RELATED QUESTIONS

Communication over ______ is be made up of voice, data, images and text messages.


Define Intranet.


What is the uses of mobile networks?


The first line of the HTTP request message is called ______. 


Which of the following `"TCP"/"IP"` protocols is used for transferring files from one machine to another?   


______ is a protocol (set of rules) used when transmitting files (data) over the world wide web. 


What is a Hypertext link?


Give the name and the syntax for the HTML tag which is used for creating a Hypertext Link.


Write the difference between SMTP and POP3.


Read the case study given below and Attempt the questions:

Bidya is a nurse at XYZ hospital. Owing to the emergency situation due to COVID-19, she needs to communicate in almost real-time with the Medical Superintendent about the status of the patients. The hospital has provided her with a laptop, web camera, and other accessories for communication purposes.
  1. As instructed by the Medical Superintendent, Bidya has to send the RT-PCR reports of some patients who have tested negative to their respective family members using her laptop. Which web service should she avail of?
  2. Bidya wants to establish a connection with the remote computer of the pathology lab in the city so that she can see the RT-PCR reports of her patients. Which protocol will be used for the same?
  3. Bidya has also been instructed by the Medical Superintendent to upload the RT-PCR reports to the Hospital's Data Server. Which Internet protocol shall be used during this process of uploading the reports to the Hospital's Server ?
  4. The Medical Superintendent has asked Bidya to inform him about the billing and payment details of the admitted patients. Bidya needs to securely access the details from the Hospital's server using her Admin Login Credentials. Which secured network protocol is she using to access the account details for the patients?
  5. Bidya, during her free time, likes to browse the Internet for products available for Online Shopping. Which Internet protocol does Bidya use while browsing for such products?

Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×