English

An electric fan runs from the 230 V mains. The current flowing through it is 0.4 A. At what rate is electrical energy transferred by the fan?

Advertisements
Advertisements

Question

An electric fan runs from the 230 V mains. The current flowing through it is 0.4 A. At what rate is electrical energy transferred by the fan?

Sum
Advertisements

Solution

Rate of electrical energy transfer = Power consumed

∴ Rate of electrical energy transfer,

P = VI

= `230 V xx0 .4 A`

= 92 W

= 92 J/s                                

shaalaa.com
  Is there an error in this question or solution?
Chapter 4: Electricity - Exercise 7

APPEARS IN

Lakhmir Singh Physics [English] Class 10
Chapter 4 Electricity
Exercise 7 | Q 28

Video TutorialsVIEW ALL [1]

RELATED QUESTIONS

1 calorie =  _________ joule.


A 2 kWh heater, a 200 W TV and three 100 W lamps are all switched on from 6 p.m. to 10 p.m. What is the total cost at Rs 5.50 per kWh?


Write an expression for the electrical power spent in flow of current through a conductor in terms of
(a) Resistance and potential difference, (b) current and resistance.


Electrical power P is given by the expression P = (Q × V) ÷ time. What do the symbols Q and V represent?


State the S.I. unit of electrical power.


A resistor of resistance R is connected to an ideal battery. If the value of R is decreased, the power dissipated in the resistor will ______________ .


What changes in energy occur in an electric heater?


Give two precautious that you would take while putting off an electric switch.


How is the amount of heat produced calculated due to the passage of current in a metallic conductor? Derive an expression for it.


What is the resistance of an appliance rated at V volt, P watt?


Find the heat produced in joules when a current of 10 amperes flows through a connecting wire of resistance 2 × 10-2 ohms and heating element of resistance 250 ohms for 2 seconds.


An electric lamp A of 40 W and another electric lamp B of 100 W are connected to 220 V supply. Calculate the ratio of their filament resistances?


An electric bulb is rated as 100W – 250V. What information does it convey? Calculate the resistance of its filament while glowing.


A bulb is connected to a battery of e.m.f. 6V and internal resistance 2Ω A steady current of 0.5A flows through the bulb. Calculate the total energy supplied by the battery in 10 minutes.


A battery of e.m.f. 12V and internal resistance 1.6 Ω is connected to two resistors of 4Ω and 6Ω connected in parallel. Calculate:
(i) the current drawn from the battery,
(ii) the power dissipated in each resistor,
(ii)the total power supplied by the battery.


1 mV is equal to:


1 kWh = ____________


Compare the power used in the 2 Ω resistor in each of the following circuits:

  1. a 6 V battery in series with 1 Ω and 2 Ω resistors
  2. a 4 V battery in parallel with 12 Ω and 2 Ω resistors.

A room has AC run for 5 hours a day at a voltage of 220V. The wiring of the room consists of Cu of 1 mm radius and a length of 10 m. Power consumption per day is 10 commercial units. What fraction of it goes in the joule heating in wires? What would happen if the wiring is made of aluminium of the same dimensions?

`[ρ_(Cu) = 1.7 xx 10_(Ωm)^-8, ρ_(Al) = 2.7 xx 10^-8 Ωm]`


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×