Advertisements
Advertisements
प्रश्न
An electric fan runs from the 230 V mains. The current flowing through it is 0.4 A. At what rate is electrical energy transferred by the fan?
Advertisements
उत्तर
Rate of electrical energy transfer = Power consumed
∴ Rate of electrical energy transfer,
P = VI
= `230 V xx0 .4 A`
= 92 W
= 92 J/s
APPEARS IN
संबंधित प्रश्न
What determines the rate at which energy is delivered by a current?
In a house two 60 W electric bulbs are lighted for 4 hours, and three 100 W bulbs for 5 hours everyday. Calculate the electric consumed in 30 days.
What is meant by "electric power"?
The diagram below shows a circuit containing a lamp L, a voltmeter and an ammeter,. The voltmeter reading 3 V and the ammeter reading is 0.5 A.
What is the resistance of the lamp?
What is the power of the lamp?
The unit for expressing electric power is:
(a) volt
(b) joule
(c) coulomb
(d) watt
An electric bulb is rated at 220 V, 100 W. (a) what is its resistance? (b) what safe current can be passed through it?
Water in an electric kettle connected to a 220 V supply took 5 minutes to reach its boiling point. How long would it have taken if the supply voltage had fallen to 200 V?
A current passes through a resistor. Let K1 and K2 represent the average kinetic energy of the conduction electrons and the metal ions, respectively.
What is the current I in the given circuit (Fig. )?
Tick(✓) the correct choice in the following:
In the circuit shown in the following fig, the e.m.f. of the cell is 4 volts, the current
flowing through the resistor is
Define Kilo watt hour.
Name two common material used for heating elements.
‘The current rating of a fuse is 5A’. Comment on this statement.
State the reason why, in a three pin plug, the earth pin is longer and thicker than the other two.
A bulb is connected to a battery of e.m.f. 6V and internal resistance 2Ω A steady current of 0.5A flows through the bulb. Calculate the total energy supplied by the battery in 10 minutes.
A bulb is marked 100W, 220V and an electric heater is marked 2000 W, 220 V.
(i) What is the ratio between the resistances of these two devices?
(ii) How does the power-voltage rating of a device help us to decide about the type of leads (connecting wires) to be used for it?
(iii) In which of the above two devices, a thicker connecting wire of lead is required?
A 100-watt electric bulb is used for 5 hours daily and four 60 watt bulbs are used for 5 hours daily. Calculate the energy consumed (in kWh) in the month of January.
A fuse is rated 5 A. Can it be used with a geyser rated 1540 W, 220 V Write Yes or No. Give supporting calculations to justify your answer.
