Advertisements
Advertisements
प्रश्न
Which of the following characteristic is not suitable for a fuse wire?
(a) thin and short
(b) thick and short
(c) low melting point
(d) higher resistance than rest of wiring
Advertisements
उत्तर
thick and short
This is so because in this case, the resistance of the wire will be low.
APPEARS IN
संबंधित प्रश्न
Write Joule's law of heating.
How much heat will an instrument of 12 W produce in one minute if it is connected to the heat produced by it?
The elements of electrical heating devices are usually made of:
(a) tungsten
(b) bronze
(c) nichrome
(d) argon
The heat produced in a wire of resistance 'x' when a current 'y' flows through it in time 'z' is given by:
(a) x2 × y × z
(b) x × z × y2
(c) y × z2 × x
(d) y × z × x
If the current flowing through a fixed resistor is halved, the heat produced in it will become:
Give a scientific reason.
Tungsten metal is used to make a solenoid type coil in an electric bulb.
An electric iron of 1100 W is operated for 2 hrs daily. What will be the electrical consumption expenses for that in the month of April? (The electric company charges Rs 5 per unit of energy).
Why does tungsten metal used to make solenoid type coil in an electric bulb?
Solve the following question.
Compute the heat generated while transferring 96000 coulombs of charge in two hours through a potential difference of 40 V.
Which of the following substance contracts on heating?
Name some devices that run using heat effect of electric current
An electric component used as a safety device is electric circuit is ______.
An electric cell produces electricity from the ______ ______ in it.
An electrochemical cell converts ______ energy into ______ energy.
A fuse is used in an electric circuit to stop high currents flowing through the circuit.
What is the heating effect of electric current?
When a current I flows through a wire of resistance R for time t then the electrical energy produced is given by ______.
An electric iron of resistance 20 Ω draws a current of 5 A. The heat developed in the iron in 30 seconds is ______.
The graph of voltage vs current for four different materials is shown below.
Which of these four materials would be used for making filament of bulb?
