Advertisements
Advertisements
प्रश्न
Obtain if the circuit is connected to a 110 V, 12 kHz supply? Hence, explain the statement that a capacitor is a conductor at very high frequencies. Compare this behaviour with that of a capacitor in a dc circuit after the steady state.
Advertisements
उत्तर
Capacitance of the capacitor, C = 100 μF = 100 × 10−6 F
Resistance of the resistor, R = 40 Ω
Supply voltage, V = 110 V
Frequency of the supply, v = 12 kHz = 12 × 103 Hz
Angular Frequency, ω = 2 πv = 2 × π × 12 × 103 Hz = 24π × 103 rad/s
Peak voltage, V0 = `"V"sqrt2 = 110 sqrt2 "V"`
Maximum current, I0 = `"V"_0/sqrt("R"^2 + 1/(ω^2"C"^2))`
= `(110 sqrt2)/sqrt((40)^2 + 1/(24π xx 10^3 xx 100 xx 10^-6)^2)`
= `(110 sqrt2)/sqrt(1600 + (10/(24π))^2)`
= 3.9 A
For an RC circuit, the voltage lags behind the current by a phase angle of Φ given as:
`tan phi = (1/(ω"C"))/"R" = 1/(ω"CR")`
= `1/(24π xx 10^3 xx 100 xx 10^-6 xx 40)`
`tan phi = 1/(96π)`
∴ `phi` ≃ 0.2°
= `(0.2π)/180 "rad"`
∴ Time lag = `phi/ω`
= `(0.2π)/(180 xx 24π xx 10^3)`
= 1.55 × 10−3 s
= 0.04 μs
Hence, Φ tends to become zero at high frequencies. At a high frequency, capacitor C acts as a conductor.
In a dc circuit, after the steady state is achieved, ω = 0. Hence, capacitor C amounts to an open circuit.
APPEARS IN
संबंधित प्रश्न
An inductor, a resistance and a capacitor are joined in series with an AC source. As the frequency of the source is slightly increased from a very low value, the reactance
A coil of inductance 0.50 H and resistance 100 Ω is connected to a 240 V, 50 Hz ac supply.
(a) What is the maximum current in the coil?
(b) What is the time lag between the voltage maximum and the current maximum?
Obtain if the circuit is connected to a high-frequency supply (240 V, 10 kHz). Hence, explain the statement that at very high frequency, an inductor in a circuit nearly amounts to an open circuit. How does an inductor behave in a dc circuit after the steady state?
An applied voltage signal consists of a superposition of a dc voltage and an ac voltage of high frequency. The circuit consists of an inductor and a capacitor in series. Show that the dc signal will appear across C and the ac signal across L.
Alternating current is so called because _______.
If circuit containing inductance only, the current ______.
An inductive circuit contains resistance of 10 ohms and an inductance of 2 henry. If an A.C. voltage of 120 Volts and frequency 60 Hz is applied to this circuit, the current would be nearly ______.
Explain why the reactance offered by an inductor increases with increasing frequency of an alternating voltage.
The magnetic energy stored in an inductor of inductance 4 µH carrying a current of 2 A is ______.
In an AC circuit with a bulb and inductor, what happens to the bulb’s brightness when an iron rod is inserted into the inductor?
A series LCR circuit is subjected to an AC signal of 200 V, 50 Hz. If the voltage across the inductor (L = 10 mH) is 31.4 V, then the current in this circuit is ______.
Why does an inductor continuously oppose changes in current?
Which equation results from applying Kirchhoff's Voltage Law to the pure inductor?
What expression for current is obtained by integrating \[\frac{di}{dt}=\frac{v_m}{L}\sin\omega t\]?
Which sine-form expression gives the current through the pure inductor?
What is \[25.0\,\mathrm{mH}\] expressed in henries?
How do transformer cores operate to enable efficient transfer of electrical energy between coils?
Which principle transfers electrical energy wirelessly between coils in wireless charging?
