Advertisements
Advertisements
प्रश्न
An inductor-coil, a capacitor and an AC source of rms voltage 24 V are connected in series. When the frequency of the source is varied, a maximum rms current of 6.0 A is observed. If this inductor coil is connected to a battery of emf 12 V and internal resistance 4.0 Ω, what will be the current?
Advertisements
उत्तर
RMS value of voltage, Erms = 24 V
Internal resistance of battery, r = 4 Ω
RMS value of current, Irms = 6 A
Reactance (R) is given by,
`R = E/I_{rms}`
`rArr R = 24/6 =4 Ω`
Let R' be the total resistance of the circuit. Then,
R' = R + r
`rArr R = 4Ω + 4Ω `
`rArr R = 8 Ω `
Current, I = `12/8 A`
= 1.5 A
APPEARS IN
संबंधित प्रश्न
An inductor, a resistance and a capacitor are joined in series with an AC source. As the frequency of the source is slightly increased from a very low value, the reactance
An inductor coil of some resistance is connected to an AC source. Which of the following quantities have zero average value over a cycle?
(a) Current
(b) Induced emf in the inductor
(c) Joule heat
(d) Magnetic energy stored in the inductor
Show that in an AC circuit containing a pure inductor, the voltage is ahead of current by π/2 in phase.
A 44 mH inductor is connected to 220 V, 50 Hz ac supply. Determine the rms value of the current in the circuit.
Obtain if the circuit is connected to a 110 V, 12 kHz supply? Hence, explain the statement that a capacitor is a conductor at very high frequencies. Compare this behaviour with that of a capacitor in a dc circuit after the steady state.
In a circuit containing resistance only, voltage and current are ______.
A current of 4A flows in a coil when connected to a 12V dc source. If the same coil is connected to a 12V, 50 rad/s a.c. source, a current of 2.4A flows in the circuit. Determine the inductance of the coil.
An inductor of inductance L, a capacitor of capacitance C and a resistor of resistance ‘R’ are connected in series to an ac source of potential difference ‘V’ volts as shown in the figure.
The potential difference across L, C, and R is 40 V, 10 V and 40 V, respectively. The amplitude of the current flowing through the LCR series circuit is `10sqrt2 "A"`. The impedance of the circuit is:
An electrical device draws 2kW power from AC mains (voltage 223V (rms) = `sqrt(50,000)` V). The current differs (lags) in phase by `phi(tan phi = (-3)/4)` as compared to voltage. Find (i) R, (ii) XC – XL, and (iii) IM. Another device has twice the values for R, XC and XL. How are the answers affected?
An ac voltage V = V0 sin ωt is applied across a pure inductor of inductance L. Find an expression for the current i, flowing in the circuit and show mathematically that the current flowing through it lags behind the applied voltage by a phase angle of `π/2`. Also draw graphs of V and i versus ωt for the circuit.
Draw a phasor diagram showing e and i in the case of a purely inductive circuit. A 40-turn square coil of side 0.2 m is placed in a magnetic field of induction 0.05 T with the plane of the coil perpendicular to the direction of the field. If the magnetic induction is uniformly reduced to zero in 5 milliseconds, find the emf induced in the coil.
A series LCR circuit is subjected to an AC signal of 200 V, 50 Hz. If the voltage across the inductor (L = 10 mH) is 31.4 V, then the current in this circuit is ______.
Which equation results from applying Kirchhoff's Voltage Law to the pure inductor?
What differential equation follows when \[v=v_m\sin\omega t\] is applied across a pure inductor?
Why is the integration constant \[C\] taken as \[0\]?
What is the current amplitude \[i_m\] for a pure inductor?
What is the rms current when \[V_{\mathrm{rms}}=220\,\mathrm{V}\] and \[X_L\approx7.85\,\Omega\]?
