Advertisements
Advertisements
प्रश्न
An inductor, a resistance and a capacitor are joined in series with an AC source. As the frequency of the source is slightly increased from a very low value, the reactance
पर्याय
of the inductor increases
of the resistor increases
of the capacitor increases
of the circuit increases
Advertisements
उत्तर
of the inductor increases
The reactance of an inductor is given by,
`X_L = omegaL`
And the reactance of a capacitor is given by,
`Xc = 1/(omegaC)`
Here, ω = 2πf , where f is the frequency of the source. So, when f increases, ω increases.
∴ XL will increase and XC will decrease.
APPEARS IN
संबंधित प्रश्न
The magnetic field energy in an inductor changes from maximum to minimum value in 5.0 ms when connected to an AC source. The frequency of the source is
An inductance of 2.0 H, a capacitance of 18μF and a resistance of 10 kΩ is connected to an AC source of 20 V with adjustable frequency.
(a) What frequency should be chosen to maximize the current in the circuit?
(b) What is the value of this maximum current?
Show that in an AC circuit containing a pure inductor, the voltage is ahead of current by π/2 in phase.
A coil of inductance 0.50 H and resistance 100 Ω is connected to a 240 V, 50 Hz ac supply.
(a) What is the maximum current in the coil?
(b) What is the time lag between the voltage maximum and the current maximum?
Obtain if the circuit is connected to a high-frequency supply (240 V, 10 kHz). Hence, explain the statement that at very high frequency, an inductor in a circuit nearly amounts to an open circuit. How does an inductor behave in a dc circuit after the steady state?
Obtain if the circuit is connected to a 110 V, 12 kHz supply? Hence, explain the statement that a capacitor is a conductor at very high frequencies. Compare this behaviour with that of a capacitor in a dc circuit after the steady state.
An applied voltage signal consists of a superposition of a dc voltage and an ac voltage of high frequency. The circuit consists of an inductor and a capacitor in series. Show that the dc signal will appear across C and the ac signal across L.
In a circuit containing resistance only, voltage and current are ______.
Average power supplied to an inductor over one complete cycle is ______.
If circuit containing inductance only, the current ______.
A current of 4A flows in a coil when connected to a 12V dc source. If the same coil is connected to a 12V, 50 rad/s a.c. source, a current of 2.4A flows in the circuit. Determine the inductance of the coil.
An inductive circuit contains resistance of 10 ohms and an inductance of 2 henry. If an A.C. voltage of 120 Volts and frequency 60 Hz is applied to this circuit, the current would be nearly ______.
An inductor of inductance L, a capacitor of capacitance C and a resistor of resistance ‘R’ are connected in series to an ac source of potential difference ‘V’ volts as shown in the figure.
The potential difference across L, C, and R is 40 V, 10 V and 40 V, respectively. The amplitude of the current flowing through the LCR series circuit is `10sqrt2 "A"`. The impedance of the circuit is:
An electrical device draws 2kW power from AC mains (voltage 223V (rms) = `sqrt(50,000)` V). The current differs (lags) in phase by `phi(tan phi = (-3)/4)` as compared to voltage. Find (i) R, (ii) XC – XL, and (iii) IM. Another device has twice the values for R, XC and XL. How are the answers affected?
What is the ratio of inductive and capacitive reactance in an ac circuit?
Draw a phasor diagram showing e and i in the case of a purely inductive circuit. A 40-turn square coil of side 0.2 m is placed in a magnetic field of induction 0.05 T with the plane of the coil perpendicular to the direction of the field. If the magnetic induction is uniformly reduced to zero in 5 milliseconds, find the emf induced in the coil.
