Advertisements
Advertisements
प्रश्न
A circular coil of cross-sectional area 200 cm2 and 20 turns is rotated about the vertical diameter with angular speed of 50 rad s−1 in a uniform magnetic field of magnitude 3.0 × 10−2T. Calculate the maximum value of the current in the coil.
Advertisements
उत्तर
Here, A = 200 cm2
N=20
ω = 50 rad/s
B = 3.0× 10−2 T
for maximum current emf induced should be maximum.
So, for maximum emf sinωt in e = NAB ω sinωt should be 1.
Hence, e = NABω
`e = 20 × 200/10000 × 50 × 3 × 10^-2 `
`e= 0.6 V`
Since, resistance of the circular loop is not given, let us consider its resistance to be R.
Therefore, current I in the coil is
`I = 0.6/R A`
संबंधित प्रश्न
Explain why, an electromagnet is called a temporary magnet.
State the factors on which the strength of an electromagnet depends. How does it depend on these factors?
Show diagrammatically how an alternating emf is generated by a loop of wire rotating in a magnetic field. Write the expression for the instantaneous value of the emf induced in the rotating loop.
Calculate the dimensions of (a) \[\int \overrightarrow{E} . d \overrightarrow{l,}\] (b) vBl and (c) \[\frac{d \Phi_B}{dt}.\] The symbols have their usual meaning.
Figure shows a long U-shaped wire of width l placed in a perpendicular magnetic field B. A wire of length l is slid on the U-shaped wire with a constant velocity v towards right. The resistance of all the wires is r per unit length. At t = 0, the sliding wire is close to the left edge of the U-shaped wire. (a) Calculate the force needed to keep the sliding wire moving with a constant velocity v. (b) If the force needed just after t = 0 is F0, find the time at which the force needed will be F0/2.0
Draw and label the diagram of a simple D.C. motor.
(a) Explain the rotation of the coil, giving a reason for your answer.
(b) How can you reverse the direction of rotation of the armature?
(c) How can you increase the speed of rotation of the motor?
What is an electromagnet? What do you know about the simplest form of an electromagnet?
Write Fleming’s right hand thumb rule with the help of diagram.
The condition for the praenomen of electromagnetic induction is that there must be a relative motion between ____________.
In the given circuit, initially switch S1 is closed and S2 and S3 are open. After charging of capacitor, at t = 0, S1 is open and S2 and S3 are closed. If the relation between inductance capacitance and resistance is L = 4CR2 then the time (in sec) after which current passing through capacitor and inductor will be same is ______ × 10-4 N. (Given R = ℓn(2)mΩ, L = 2mH)
