Advertisements
Advertisements
प्रश्न
Two resistors, with resistance 5 Ω and 10 Ω respectively are to be connected to a battery of emf 6 V so as to obtain:
(i) minimum current flowing
(ii) maximum current flowing
(a) How will you connect the resistances in each case?
(b) Calculate the strength of the total current in the circuit in the two cases.
Advertisements
उत्तर
a) For the minimum current flowing in the circuit, the resistors should be connected in series and for the maximum current in the circuit, the resistors should be connected in parallel with the battery.
(b) When the resistors are connected in parallel:
Resistance in parallrl arrangement is given
`1/R=1/R_1+1/R_2`
Here `R_1=5`Ω
`R_2=10`Ω
`1/R=1/5+1/10`
`or1/R=(10+5)/50`
`or1/R=15//50`
`R=50/15=3.33`Ω
Total resistance = 3.33 Ω
Therefore, strength of the total current, I = V / R
I = 6 / 3.33
I = 1.8 A
When the resistors are connected in series, the resultant resistance is given by R = R1 + R2
Here, R1 = 5 Ω
R2= 10 Ω
So, R = 5Ω+ 10Ω = 15 Ω
Total resistance = 15 Ω
Therefore, strength of the total current, I = 6 / 15 = 0.4 A
APPEARS IN
संबंधित प्रश्न
Complete the following :-
(b)
What are the advantages of connecting electrical devices in parallel with the battery instead of connecting them in series?
How can three resistors of resistances 2 Ω, 3 Ω and 6 Ω be connected to give a total resistance of 4 Ω ?
A hot plate of an electric oven connected to a 220 V line has two resistance coils A and B, each of 24 Ω resistances, which may be used separately, in series, or in parallel. What are the currents in the three cases?
Explain with the help of a labelled circuit diagram, how you will find the resistance of a combination of three resistors of resistances R1, R2 and R3 joined in parallel.
State how are the two resistors joined with a battery when potential difference is same across each resistor.
In parallel combination of resistances ______.
Which of the following combinations have the same equivalent resistance between X and Y?
Five resistors, each 3 Ω, are connected as shown in Fig. Calculate the resistance
- between the points P and Q.
- between the points X and Y.
Explain, why is the p.d. between the terminals of a storage battery less when it is supplying current than when it is on open circuit. A battery of e.m.f. 10 volts and internal resistance 2.5 ohms has two resistances of 50 ohms each connected to it. Calculate the power dissipated in each resistance
(a) When they are in series,
(b) When they are in parallel.
In each case calculate the power dissipated in the battery.
A cell supplies a current of 1.2 A through two 2Ω resistors connected in parallel. When the resistors are connected in series, if supplies a current of 0.4 A. Calculate the internal resistance and e.m.f of the cell.
A particular resistance wire has a resistance of 3 ohm per meter. Find :
The total resistance of three lengths of this wire each 1.5 m long, in parallel.
An electrical appliance having a resistance of 200 Ω is operated at 200 V. Calculate the energy consumed by the appliance in 5 minutes in kWh.
How does the resistance of a metallic wire depend on the thickness of wire?
In the figure below, the ammeter A reads 0.3 A. Calculate:
(i) the total resistance of the circuit
(ii) the value of R
(iii) the current flowing through R.
Three resistors of 1 Ω, 2 Ω and 3 Ω are connected in parallel. The combined resistance of the three resistors should be:
Assertion: When a battery is short circuited, the terminal voltage is zero.
Reason: In a short circuit, the current is zero.
Three resistors of 6Ω, 4Ω and 4Ω are connected together so that the total resistance is 8Ω. Draw a diagram to show this arrangement and give reason to justify your answer.
Two resistors of resistances 2 Ω and 3 Ω are connected in parallel to a cell to draw current 0.5 A from the cell. Draw a labelled diagram of the arrangement
