Advertisements
Advertisements
प्रश्न
For an amplitude modulated wave, the maximum amplitude is found to be 10 V while the minimum amplitude is found to be 2 V. Determine the modulation index μ. What would be the value of μ if the minimum amplitude is zero volt?
Advertisements
उत्तर
Maximum amplitude, Amax = 10 V
Minimum amplitude, Amin = 2 V
Modulation index μ, is given by the relation:
`mu= (A_"max" - A_"min")/(A_"max" + A_"min")`
`= (10 - 2)/(10 + 2) = 8/12 = 0.67`
if A_"min" = 0
Then `mu = A_"max"/A_"max"= 10/10 = 1`
संबंधित प्रश्न
Explain any two factors that justify the need of modulating a low-frequency signal.
Draw a block diagram of a detector for AM signal and show, using necessary processes and the waveforms, how the original message signal is detected from the input AM wave.
Explain the process of amplitude modulation.
How is amplitude modulation achieved?
Explain any two factors which justify the need for modulating a low frequency base-band signal.
Write two advantages of frequency modulation over amplitude modulation.
Write three important factors which justify the need of modulating a message signal. Show diagrammatically how an amplitude modulated wave is obtained when a modulating signal is superimposed on a carrier wave.
What is meant by term ‘modulation’? Draw a block diagram of a simple modulator for obtaining an AM signal.
Why is frequency modulation preferred over amplitude modulation for transmission of music?
Answer the following question.
If A and B represent the maximum and minimum amplitudes of an amplitude-modulated wave, write the expression for the modulation index in terms of A and B.
Solve the following question.
A message signal of frequency 20 kHz and peak voltage 10 V is used to modulate a carrier of frequency 2 MHz and peak voltage of 15 V. Calculate the modulation index. Why the modulation index is generally kept less than one?
A message signal of frequency ωm is superposed on a carrier wave of frequency ωc to get an amplitude modulated wave (AM). The frequency of the AM wave will be ______.
Compute the LC product of a tuned amplifier circuit required to generate a carrier wave of 1 MHz for amplitude modulation.
Why is a AM signal likely to be more noisy than a FM signal upon transmission through a channel?
An amplitude modulated wave is as shown in figure. Calculate
- the percentage modulation
- peak carrier voltage and
- peak value of information voltage.
An amplitude-modulated wave is represented by Cm(t) = 10(1 + 0.2 cos 12560t) × sin (111 × 104t) volts. The modulating frequency in kHz will be ______.
The maximum and minimum voltage of an amplitude modulated signal are 60 V and 20 V respectively. The percentage modulation index will be ______.
A signal of 5 kHz frequency is amplitude modulated on a carrier wave of frequency 2 MHz. The frequencies of the resultant signal are ______.
