Advertisements
Advertisements
प्रश्न
An amplitude modulated wave is as shown in figure. Calculate
- the percentage modulation
- peak carrier voltage and
- peak value of information voltage.
Advertisements
उत्तर
From the figure
`V_(max) = 100/2 = 50V, V_(min) = 20/2 = 10 V`.
i. Percentage modulation = `mu(%) = (V_(max) - V_(min))/(V_(max) + V_(min)) xx 100`
= `((50 - 10)/(50 + 10)) xx 100`
= `40/60 xx 100`
= 66.67%
ii. Peak carrier voltage = `V_c = (V_(max) + V_(min))/2`
= `(50 + 10)/2`
= 30 V
iii. Peak information voltage = `V_m = muV_c`
= `2/3 xx 30`
= 20 V.
APPEARS IN
संबंधित प्रश्न
Explain any two factors that justify the need of modulating a low-frequency signal.
Draw a block diagram of a detector for AM signal and show, using necessary processes and the waveforms, how the original message signal is detected from the input AM wave.
Explain the process of amplitude modulation.
A modulating signal is a square wave, as shown
The carrier wave is given by `c(t) = 2 sin (8pit) "volts"`
(i) Sketch the amplitude modulated waveform
(ii) What is the modulation index?
How is amplitude modulation achieved?
The frequencies of two side bands in an AM wave are 640 kHz and 660 kHz respectively. Find the frequencies of carrier and modulating signal. What is the bandwidth required for amplitude modulation?
Define the term 'amplitude modulation'
Explain any two factors which justify the need for modulating a low frequency base-band signal.
What is meant by term ‘modulation’? Draw a block diagram of a simple modulator for obtaining an AM signal.
Why is frequency modulation preferred over amplitude modulation for transmission of music?
Answer the following question.
If A and B represent the maximum and minimum amplitudes of an amplitude-modulated wave, write the expression for the modulation index in terms of A and B.
In amplitude modulation ______.
Identify the mathematical expression for amplitude modulated wave ______.
In amplitude modulation, the modulation index m, is kept less than or equal to 1 because ______.
- m > 1, will result in interference between carrier frequency and message frequency, resulting into distortion.
- m > 1 will result in overlapping of both side bands resulting into loss of information.
- m > 1 will result in change in phase between carrier signal and message signal.
- m > 1 indicates amplitude of message signal greater than amplitude of carrier signal resulting into distortion.
Draw the plot of amplitude versus ‘ω’ for an amplitude modulated wave whose carrier wave (ωc) is carrying two modulating signals, ω1 and ω2 (ω2 > ω1).
- Is the plot symmetrical about ωc? Comment especially about plot in region ω < ωc.
- Extrapolate and predict the problems one can expect if more waves are to be modulated.
- Suggest solutions to the above problem. In the process can one understand another advantage of modulation in terms of bandwidth?
An audio signal vm = 20sin2π(1500t) amplitude modulates a carrier vc = 80 sin 2π (100,000t). The value of percent modulation is ______.
A signal of 5 kHz frequency is amplitude modulated on a carrier wave of frequency 2 MHz. The frequencies of the resultant signal are ______.
