Advertisements
Advertisements
प्रश्न
Block diagram of a receiver is shown in the figure:
(a) Identify ‘X’ and ‘Y’.
(b) Write their functions.
Advertisements
उत्तर
From the given block diagram of Demodulation of a typical receiver, we can conclude the following,
(a) X represents Intermediate Frequency (IF) stage while Y represents an Amplifier.
(b) At IF stage, the carrier frequency is changed to a lower frequency and in this process, the modulated signal is detected. While the function of amplifier is to amplify the detected signal which may not be strong enough to be made use of and hence is required.
APPEARS IN
संबंधित प्रश्न
Digital signals
(i) Do not provide a continuous set of values,
(ii) Represent values as discrete steps,
(iii) Can utilize binary system, and
(iv) Can utilize decimal as well as binary systems.
Which of the above statements are true?
(a) (i) and (ii) only
(b) (ii) and (iii) only
(c) (i), (ii) and (iii) but not (iv)
(d) All of (i), (ii), (iii) and (iv).
Answer the following question :
Define 'bandwidth' and describe briefly its importance in communicating signals ?
Draw a diagram showing an amplitude modulated wave by superposing a modulating signal over a sinusoidal carrier wave.
Write briefly any two factors which demonstrate the need for modulating a signal. Draw a suitable diagram to show amplitude modulation using a sinusoidal signal as the modulating signal.
Differentiate between Analog and Digital communication.
The area of the region covered by the TV broadcast by a TV tower of 100 m height is (Radius of the earth = 6.4 × 106 m):
Long distance short-wave radio broadcasting uses
What is meant by deviation in frequency of FM wave?
The audio frequency range is
Broadcast band in which FM lies is ______.
