Advertisements
Advertisements
प्रश्न
Block diagram of a receiver is shown in the figure:
(a) Identify ‘X’ and ‘Y’.
(b) Write their functions.
Advertisements
उत्तर
From the given block diagram of Demodulation of a typical receiver, we can conclude the following,
(a) X represents Intermediate Frequency (IF) stage while Y represents an Amplifier.
(b) At IF stage, the carrier frequency is changed to a lower frequency and in this process, the modulated signal is detected. While the function of amplifier is to amplify the detected signal which may not be strong enough to be made use of and hence is required.
APPEARS IN
संबंधित प्रश्न
Which of the following frequencies will be suitable for beyond-the-horizon communication using sky waves?
(a) 10 kHz
(b) 10 MHz
(c) 1 GHz
(d) 1000 GHz
Answer the following question :
Define 'bandwidth' and describe briefly its importance in communicating signals ?
Distinguish between ‘Analog and Digital signals’.
Write any two factors which justify the need for modulating a signal ?
Write briefly any two factors which demonstrate the need for modulating a signal. Draw a suitable diagram to show amplitude modulation using a sinusoidal signal as the modulating signal.
Differentiate between Analog and Digital communication.
A TV tower has a height of 100 meter. If the coverage range is to be made three times then the height of the tower should be increased by.
What is meant by deviation in frequency of FM wave?
The audio frequency range is
Broadcast band in which FM lies is ______.
