Advertisements
Advertisements
प्रश्न
A long solenoid with 15 turns per cm has a small loop of area 2.0 cm2 placed inside the solenoid normal to its axis. If the current carried by the solenoid changes steadily from 2.0 A to 4.0 A in 0.1 s, what is the induced emf in the loop while the current is changing?
Advertisements
उत्तर
Number of turns on the solenoid = 15 turns/cm = 1500 turns/m
Number of turns per unit length, n = 1500 turns
The solenoid has a small loop of area, A = 2.0 cm2
= 2 × 10−4 m2
Current carried by the solenoid changes from 2 A to 4 A.
∴ Change in current in the solenoid, di = 4 − 2 = 2 A
Change in time, dt = 0.1 s
Induced emf in the solenoid is given by Faraday’s law as:
`"e" = ("d"phi)/("dt")` ........(1)
Where,
`phi` = Induced flux through the small loop = BA ...........(2)
B = Magnetic field = `mu_0"ni"` .....(3)
μ0 = Permeability of free space
= 4π × 10−7 H/m
Hence, equation (1) reduces to:
`"e" = "d"/("dt")("BA")`
= `"A"mu_0"n" xx (("di")/("dt"))`
= `2 xx 10^-4 xx 4pi xx 10^-7 xx 1500 xx 2/0.1`
= 7.54 × 10−6 V
Hence, the induced voltage in the loop is 7.54 × 10−6 V.
APPEARS IN
संबंधित प्रश्न
The co-efficient of mutual induction between primary and secondary coil is 2H. Calculate induced e.m.f. if current of 4A is cut off in 2.5 x 10-4 seconds
If the radius of a sphere is doubled without changing the charge on it, then electric flux originating from the sphere is ______.
An air-cored solenoid with length 30 cm, area of cross-section 25 cm2 and number of turns 500, carries a current of 2.5 A. The current is suddenly switched off in a brief time of 10−3 s. How much is the average back emf induced across the ends of the open switch in the circuit? Ignore the variation in magnetic field near the ends of the solenoid.
The current in a long solenoid of radius R and having n turns per unit length is given by i= i0 sin ωt. A coil having N turns is wound around it near the centre. Find (a) the induced emf in the coil and (b) the mutual inductance between the solenoid ant the coil.
A solenoid of length 20 cm, area of cross-section 4.0 cm2 and having 4000 turns is placed inside another solenoid of 2000 turns having a cross-sectional area 8.0 cm2 and length 10 cm. Find the mutual inductance between the solenoids.
Two coils P and Q are kept near each other. When no current flows through coil P and current increases in coil Q at the rate 10 A/s, the e.m.f. in coil P is 20 mV. When coil Q carries no current and current of 1.6 A flows through coil P, the magnetic flux linked with the coil Q is ____________.
If number of turns in primary and secondary coils is increased to two times each, the mutual inductance ______.
Two coils are placed close to each other. The mutual inductance of the pair of coils depends upon the ______.
Two conducting circular loops of radii R1 and R2 are placed in the same plane with their centres coinciding. If R1 > > R2, the mutual inductance M between them will be directly proportional to ______.
The coefficient of mutual induction is 2 H and induced e.m.f. across secondary is 2 kV. Current in the primary is reduced from 6 A to 3 A. The time required for the change of current is ______.
The mutual inductance between a primary and secondary circuit is 0.4 H and the resistance in these circuits are \[20\Omega\] and \[4\Omega\] respectively. To produce a current of 0.5 A in the secondary, current in the primary must be changed at the rate of ______.
Which relation defines mutual inductance using the flux linkage \[N_2\phi_{21}\] and current \[I_1\] ?
What maximum value of \[M\] follows from \[M=K\sqrt{L_1L_2}\] and \[0\leq K\leq 1\] ?
What is the SI unit of mutual inductance?
What is the effect of a larger cross-sectional area of the coils on mutual inductance?
What happens to mutual inductance as the distance between coils increases?
What is the magnetic field at the centre of the outer large coil when it carries current \[I_2\] ?
Why can \[B_2\] be assumed uniform across the entire area of the inner coil?
