Advertisements
Advertisements
Question
Which has more resistance:
a thick piece of nichrome wire or a thin piece?
Advertisements
Solution
A thin piece of nichrome wire has more resistance because the resistance of a conductor is inversely proportional to its area of cross-section, i.e. R α 1 / A. The lesser the area of cross-section, the more the resistance.
APPEARS IN
RELATED QUESTIONS
On what factors does the resistance of a conductor depend?
Two conducting wires of the same material and of equal lengths and equal diameters are first connected in series and then parallel in a circuit across the same potential difference. The ratio of heat produced in series and parallel combinations would be:
A copper wire has diameter 0.5 mm and resistivity of 1.6 × 10−8Ω m. What will be the length of this wire to make its resistance 10 Ω? How much does the resistance change if the diameter is doubled?
Why are copper and aluminium wires usually employed for electricity transmission?
Distinguish between good conductors, resistors and insulators. Name two good conductors, two resistance and two insulators.
What is meant by the "resistance of a conductor" ? Write the relation between resistance, potential difference and current.
What happens to the resistance as the conductor is made thinner?
Which has more resistance:
a long piece of nichrome wire or a short one?
What will be the resistance of a metal wire of length 2 metres and area of cross-section 1.55 × 10−6 m2 if the resistivity of the metal be 2.8 × 10−8 Ω m?
Give two examples of substances which are good conductors of electricity. Why do you think they are good conductors of electricity?
Calculate the resistance of a copper wire 1.0 km long and 0.50 mm diameter if the resistivity of copper is 1.7 × 10−8 Ω m.
How does the resistance of a conductor depend on:
length of the conductor?
What would be the effect on the resistance of a metal wire of:
increasing its length?
Calculate the area of cross-section of a wire if its length is 1.0 m, its resistance is 23 Ω and the resistivity of the material of the wire is 1.84 × 10−6 Ω m.
The figure blow shows a variable resistor in a dimmer switch.
How would you turn the switch to make the lights: (a) brighter, and (b) dimmer? Explain your answer.
Write the relation between resistance and electrical resistivity of the material of a conductor in the shape of a cylinder of length `'l'` and area of cross-section `'A'` . Hence derive the S.I. unit of electrical resistivity.
Resistance of a metal wire of length 5 m is 100 Ω . If the area of cross - section of the wire is `3 × 10^-7 "m"^2` , Calculate the resistivity of the metal .
The resistance of a wire of 0.01 cm radius is 10 Ω. If the resistivity of the wire is 50 × 10-8 Ω, find the length of this wire.
