English
Karnataka Board PUCPUC Science Class 11

A Smooth Sphere of Radius R is Made to Translate in a Straight Line with a Constant Acceleration A. a Particle Kept on the Top of the Sphere is Released at Zero Velocity with Respect to the Sphere

Advertisements
Advertisements

Question

A smooth sphere of radius R is made to translate in a straight line with a constant acceleration a. A particle kept on the top of the sphere is released at zero velocity with respect to the sphere. Find the speed of the particle with respect to the sphere as a function of the angle θ it slides. 

Numerical
Advertisements

Solution

Suppose the sphere moves to the left with acceleration 'a'
Let m be the mass of the particle.
The particle 'm' will also experience inertia due to acceleration 'a' as it is in the sphere. It will also experience the tangential inertia force

\[\left[ \text{m }\left( \frac{d\nu}{dt} \right) \right]\]  and centrifugal force \[\left( \frac{m \nu^2}{R} \right)\] .

From the diagram,
\[m\frac{d\nu}{dt} = \text{ ma } \cos \theta + \text{ mg } \sin \theta\]
\[\Rightarrow \text{ m }\nu\frac{d\nu}{dt} = \text{ma} \cdot \cos \theta \left( R\frac{d\theta}{dt} \right) + \text{ mg } \sin \theta \left( R\frac{d\theta}{dt} \right) \left( \text{ because,} \nu = R\frac{d\theta}{dt} \right)\]
\[ \Rightarrow \nu \text{ d}\nu = a \text{ R } \cos \theta \text{ d }\theta + \text{ gR } \sin \theta \text{ d }\theta\]
Integrating both sides, we get:
\[\frac{\nu^2}{2} = \text{ aR } \sin \theta - \text{ gR } \cos \theta + C\]
Given:
\[\theta = 0, \nu = 0\] 
So,
\[\text{ C = gR }\]
\[\Rightarrow \frac{\nu^2}{2} = \text{ aR } \sin \theta - \text{ gR } \cos \theta + \text{ gR }\]
\[ \Rightarrow \nu^2 = 2\text{ R } \left( a \sin \theta + g - g \cos \theta \right)\]
\[ \Rightarrow \nu = \left[ 2\text{ R }\left( a \sin \theta + g - g \cos \theta \right) \right]^{1/2}\]
shaalaa.com
  Is there an error in this question or solution?
Chapter 8: Work and Energy - Exercise [Page 137]

APPEARS IN

HC Verma Concepts of Physics Volume 1 and 2 [English]
Chapter 8 Work and Energy
Exercise | Q 64 | Page 137

RELATED QUESTIONS

In figure (i) the man walks 2 m carrying a mass of 15 kg on his hands. In Figure (ii), he walks the same distance pulling the rope behind him. The rope goes over a pulley, and a mass of 15 kg hangs at its other end. In which case is the work done greater?


A ball is given a speed v on a rough horizontal surface. The ball travels through a distance l on the surface and stops. what are the initial and final kinetic energies of the ball?  


A ball is given a speed v on a rough horizontal surface. The ball travels through a distance l on the surface and stops. What is the work done by the kinetic friction? 


The US athlete Florence Griffith-Joyner won the 100 m sprint gold medal at Seoul Olympics in 1988, setting a new Olympic record of 10⋅54 s. Assume that she achieved her maximum speed in a very short time and then ran the race with that speed till she crossed the line. Take her mass to be 50 kg. Assuming that the track, wind etc. offered an average resistance of one-tenth of her weight, calculate the work done by the resistance during the run. 


A water pump lifts water from 10 m below the ground. Water is pumped at a rate of 30 kg/minute with negligible velocity. Calculate the minimum horsepower that the engine should have to do this.

 

In a factory, 2000 kg of metal needs to be lifted by an engine through a distance of 12 m in 1 minute. Find the minimum horsepower of the engine to be used.

 

A scooter company gives the following specifications about its product:
Weight of the scooter − 95 kg
Maximum speed − 60 km/h
Maximum engine power − 3⋅5 hp
Pick up time to get the maximum speed − 5 s
Check the validity of these specifications.


A block of mass 30 kg is being brought down by a chain. If the block acquires a speed of 40 cm/s in dropping down 2 m, find the work done by the chain during the process.


A block of mass 100 g is moved with a speed of 5⋅0 m/s at the highest point in a closed circular tube of radius 10 cm kept in a vertical plane. The cross-section of the tube is such that the block just fits in it. The block makes several oscillations inside the tube and finally stops at the lowest point. Find the work done by the tube on the block during the process.


A small block of mass 200 g is kept at the top of a frictionless incline which is 10 m long and 3⋅2 m high. How much work was required (a) to lift the block from the ground and put it an the top, (b) to slide the block up the incline? What will be the speed of the block when it reaches the ground if (c) it falls off the incline and drops vertically to the ground (d) it slides down the incline? Take g = 10 m/s2. 


A simple pendulum consists of a 50 cm long string connected to a 100 g ball. The ball is pulled aside so that the string makes an angle of 37° with the vertical and is then released. Find the tension in the string when the bob is at its lowest position. 


Following figure following shows a smooth track, a part of which is a circle of radius R. A block of mass m is pushed against a spring of spring constant k fixed at the left end and is then released. Find the initial compression of the spring so that the block presses the track with a force mg when it reaches the point P, where the radius of the track is horizontal.


A particle of mass m is kept on the top of a smooth sphere of radius R. It is given a sharp impulse which imparts it a horizontal speed ν. (a) Find the normal force between the sphere and the particle just after the impulse. (b) What should be the minimum value of ν for which the particle does not slip on the sphere? (c) Assuming the velocity ν to be half the minimum calculated in part, (b) find the angle made by the radius through the particle with the vertical when it leaves the sphere.


A chain of length l and mass m lies on the surface of a smooth sphere of radius R > l with one end tied to the top of the sphere.  Find the tangential acceleration \[\frac{d\nu}{dt}\] of the chain when the chain starts sliding down.

 

A bullet of mass m fired at 30° to the horizontal leaves the barrel of the gun with a velocity v. The bullet hits a soft target at a height h above the ground while it is moving downward and emerges out with half the kinetic energy it had before hitting the target.

Which of the following statements are correct in respect of bullet after it emerges out of the target?

  1. The velocity of the bullet will be reduced to half its initial value.
  2. The velocity of the bullet will be more than half of its earlier velocity.
  3. The bullet will continue to move along the same parabolic path.
  4. The bullet will move in a different parabolic path.
  5. The bullet will fall vertically downward after hitting the target.
  6. The internal energy of the particles of the target will increase.

Give example of a situation in which an applied force does not result in a change in kinetic energy.


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×