Science (English Medium) इयत्ता ११ - CBSE Question Bank Solutions

Choose the correct alternative:

The energy required to launch an orbiting satellite out of earth’s gravitational influence is more/less than the energy required to project a stationary object at the same height (as the satellite) out of earth’s influence.

A satellite orbits the earth at a height of 400 km above the surface. How much energy must be expended to rocket the satellite out of the earth’s gravitational influence? Mass of the satellite = 200 kg; mass of the earth = 6.0 ×10²⁴ kg; radius of the earth = 6.4 ×10⁶ m; G = 6.67 × 10^–11 N m² kg^–2

A body is moving unidirectionally under the influence of a source of constant power. Its displacement in time t is proportional to ______.

A pump on the ground floor of a building can pump up water to fill a tank of volume 30 m³ in 15 min. If the tank is 40 m above the ground, and the efficiency of the pump is 30%, how much electric power is consumed by the pump?

The blades of a windmill sweep out a circle of area A.

1. If the wind flows at a velocity v perpendicular to the circle, what is the mass of the air passing through it in time t?
2. What is the kinetic energy of the air?
3. Assume that the windmill converts 25% of the wind’s energy into electrical energy, and that A = 30 m², v = 36 km/h and the density of air is 1.2 kg m^–3. What is the electrical power produced?

A family uses 8 kW of power.

1. Direct solar energy is incident on the horizontal surface at an average rate of 200 W per square meter. If 20% of this energy can be converted to useful electrical energy, how large an area is needed to supply 8 kW?
2. Compare this area to that of the roof of a typical house.

Prove the theorem of perpendicular axes.

(Hint: Square of the distance of a point (x, y) in the x–y plane from an axis through the origin perpendicular to the plane is x² + y²).

Prove the theorem of parallel axes.

(Hint: If the centre of mass is chosen to be the origin `summ_ir_i = 0`

Explain why The angle of contact of mercury with glass is obtuse, while that of water with glass is acute

Explain why Water on a clean glass surface tends to spread out while mercury on the same surface tends to form drops. (Put differently, water wets glass while mercury does not.)

Explain why Surface tension of a liquid is independent of the area of the surface

Explain why Water with detergent dissolved in it should have small angles of contact.

Explain why A drop of liquid under no external forces is always spherical in shape

Fill in the blanks using the word(s) from the list appended with each statement

Surface tension of liquids generally . . . with temperatures (increases / decreases)

A U-shaped wire is dipped in a soap solution and removed. The thin soap film formed between the wire and the light slider supports a weight of 1.5 × 10^–2 N (which includes the small weight of the slider). The length of the slider is 30 cm. What is the surface tension of the film?

Figure  (a) shows a thin liquid film supporting a small weight = 4.5 × 10^–2 N. What is the weight supported by a film of the same liquid at the same temperature in Fig. (b) and (c)? Explain your answer physically.

What is the excess pressure inside a bubble of soap solution of radius 5.00 mm, given that the surface tension of soap solution at the temperature (20 °C) is 2.50 × 10^–2 N m^–1? If an air bubble of the same dimension were formed at depth of 40.0 cm inside a container containing the soap solution (of relative density 1.20), what would be the pressure inside the bubble? (1 atmospheric pressure is 1.01 × 10⁵ Pa).

Mercury has an angle of contact equal to 140° with soda lime glass. A narrow tube of radius 1.00 mm made of this glass is dipped in a trough containing mercury. By what amount does the mercury dip down in the tube relative to the liquid surface outside? Surface tension of mercury at the temperature of the experiment is 0.465 N m^–1. Density of mercury = 13.6 × 10³ kg m^–3

Mercury has an angle of contact equal to 140° with soda lime glass. A narrow tube of radius 1.00 mm made of this glass is dipped in a trough containing mercury. By what amount does the mercury dip down in the tube relative to the liquid surface outside? Surface tension of mercury at the temperature of the experiment is 0.465 N m^–1. Density of mercury = 13.6 × 10³ kg m^–3

Two narrow bores of diameters 3.0 mm and 6.0 mm are joined together to form a U-tube open at both ends. If the U-tube contains water, what is the difference in its levels in the two limbs of the tube? Surface tension of water at the temperature of the experiment is 7.3 × 10^–2 N m^–1. Take the angle of contact to be zero and density of water to be 1.0 × 10³ kg m^–3 (g = 9.8 m s^–2)