Advertisements
Advertisements
प्रश्न
Suppose the tube in the previous problem is kept vertical with B upward. Water enters through B at the rate of 1 cm3/s. Repeat parts (a), (b) and (c). Note that the speed decreases as the water falls down.
Advertisements
उत्तर
Water enters through B at the rate of 1 cm3s−1.
(a) Speed of water at A,
\[\vec{V}_A = 25 cm/s\]v
(b) Speed of water at B,
\[\vec{V}_B = 50 cm/s\]
(c) By Bernoulli’s equation, we have:
`1/2ρv_A^2 + ρgh_A + P_A = 1/2ρvB^2 + ρgh_B + P_B`
`=> P_A - P_B = 1/2 × 1 × 1875 + 1/2 × 1000 × 15/16`
= 1875 dyn /cm2
= 188 N/m2
APPEARS IN
संबंधित प्रश्न
Explain why A spinning cricket ball in air does not follow a parabolic trajectory
In a test experiment on a model aeroplane in a wind tunnel, the flow speeds on the upper and lower surfaces of the wing are 70 m s–1and 63 m s–1 respectively. What is the lift on the wing if its area is 2.5 m2? Take the density of air to be 1.3 kg m–3.
Figures (a) and (b) refer to the steady flow of a (non-viscous) liquid. Which of the two figures is incorrect? Why?
The cylindrical tube of a spray pump has a cross-section of 8.0 cm2 one end of which has 40 fine holes each of diameter 1.0 mm. If the liquid flow inside the tube is 1.5 m min–1, what is the speed of ejection of the liquid through the holes?
In deriving Bernoulli’s equation, we equated the work done on the fluid in the tube to its change in the potential and kinetic energy. (a) What is the largest average velocity of blood flow in an artery of diameter 2 × 10–3 m if the flow must remain laminar? (b) Do the dissipative forces become more important as the fluid velocity increases? Discuss qualitatively.
A Gipsy car has a canvass top. When the car runs at high speed, the top bulges out. Explain.
Bernoulli's theorem is based on the conservation of
Water is flowing through a long horizontal tube. Let PA and PB be the pressures at two points A and B of the tube.
A large cylindrical tank has a hole of area A at its bottom. Water is poured in the tank by a tube of equal cross-sectional area A ejecting water at the speed v.
A large number of liquid drops each of radius 'a' are merged to form a single spherical drop of radius 'b'. The energy released in the process is converted into kinetic energy of the big drop formed. The speed of the big drop is [p = density of liquid, T = surface tension of liquid] ____________.
Dynamic lift caused by spinning is called ______.
The working of venturimeter is based on ______.
In the widest part of the horizontal pipe, oil is flowing at a rate of 2 m/sec. The speed (in m/s) of the flow of oil in the narrow part of the tube if the pressure difference in the broad and narrow parts of the pipe is 0.25 ρoilg, is ______ m/s.
Two wires are made of the same material and have the same volume. However wire 1 has cross-sectional area A and wire 2 has cross-sectional area 9A. If the length of wire 1 increases by Δx on applying force F, how much force is needed to stretch wire 2 by the same amount?
Explain the working of an atomizer.
