Advertisements
Advertisements
प्रश्न
Heat energy is supplied at a constant rate to 100g of ice at 0 °C. The ice is converted into water at 0° C in 2 minutes. How much time will be required to raise the temperature of water from 0 °C to 20 °C? [Given: sp. heat capacity of water = 4.2 J g-1 °C-1, sp. latent heat of ice = 336 J g-1].
100 g of ice at 0°C receives a steady flow of heat energy. At 0°C, the ice melts into the water in 2 minutes. How long will it take to bring the temperature of the water up to 20 degrees? (Specific latent heat of ice = 336 J/g, Specific heat capacity of water = 4.2 J/g °C).
Advertisements
उत्तर
Heat energy required to melt 100 g of ice at 0 °C is
Q = mL = 100 × 336=33600 J
Therefore, heat energy supplied per minute is
`33600/2=16800 "J min"^-1`
Now, heat energy required to raise the temperature of water from 0°C to 20°C is
Q'=mc × rise in temperature =100 × 4.2 × 20 = 8400 J
If time required for this heat gain is t minutes, then Heat energy supplied in t minutes is
`16800 xx "t"=8400`
`therefore "t" =8400/16800`
`"t" = 0.5 "min"`
`"t" = 30 "s"`
संबंधित प्रश्न
A solid of mass 50 g at 150 °C is placed in 100 g of water at 11 °C when the final temperature recorded is 20 °C. Find the specific heat capacity of the solid. (specific heat capacity of water = 4.2 J/g °C)
Give one example where high specific heat capacity of water is used as cooling purposes?
In Regnault's apparatus for measuring specific heat capacity of a solid, there is an inlet and an outlet in the steam chamber. The inlet is near the top and the outlet is near the bottom. Why is it better than the opposite choice where the inlet is near the bottom and the outlet is near the top?
Explain, Why is it advisabile to pour cold water over burns, caused on human body, by hot solids?
Ice-cream at 0°C feels colder than water at 0°C. Give reason for this observation.
Numerical Problem.
What could be the final temperature of a mixture of 100 g of water at 90 °C and 600g of water at 20°C.
Derive Meyer’s relation for an ideal gas.
Two uniform brass rods A and B of length land 2l and radii 2r and r respectively are heated to the same temperature. The ratio of the increase in the volume ofB to that of A is ____________.
The diagram below shows a cooling curve for 200 g of water. The heat is extracted at the rate of 100 Js-1. Answer the questions that follow:
- Calculate specific heat capacity of water.
- Heat released in the region BC.
Which of the following substances (A, B and C) has the highest specific heat?
