मराठी

Draw a Schematic Sketch Showing How Amplitude Modulated Signal is Obtained by Superposing a Modulating Signal Over a Sinusoidal Carrier Wave.

Advertisements
Advertisements

प्रश्न

Draw a schematic sketch showing how amplitude modulated signal is obtained by superposing a modulating signal over a sinusoidal carrier wave.

Advertisements

उत्तर

Amplitude modulated signal is obtained by superposing a modulating signal over a sinusoidal carrier wave is shown in the figure given below

shaalaa.com
  या प्रश्नात किंवा उत्तरात काही त्रुटी आहे का?
2013-2014 (March) All India Set 2

व्हिडिओ ट्यूटोरियलVIEW ALL [1]

संबंधित प्रश्‍न

Draw a block diagram of a detector for AM signal and show, using necessary processes and the waveforms, how the original message signal is detected from the input AM wave.


Explain the process of amplitude modulation.


A modulating signal is a square wave, as shown

The carrier wave is given by  `c(t) = 2 sin (8pit) "volts"`

(i) Sketch the amplitude modulated waveform

(ii) What is the modulation index?


Write two advantages of frequency modulation over amplitude modulation.


Solve the following question.
A message signal of frequency 20 kHz and peak voltage 10 V is used to modulate a carrier of frequency 2 MHz and peak voltage of 15 V. Calculate the modulation index. Why the modulation index is generally kept less than one? 


Identify the mathematical expression for amplitude modulated wave ______.


In amplitude modulation, the modulation index m, is kept less than or equal to 1 because ______.

  1. m > 1, will result in interference between carrier frequency and message frequency, resulting into distortion.
  2. m > 1 will result in overlapping of both side bands resulting into loss of information.
  3. m > 1 will result in change in phase between carrier signal and message signal.
  4. m > 1 indicates amplitude of message signal greater than amplitude of carrier signal resulting into distortion.

The maximum amplitude of an A.M. wave is found to be 15 V while its minimum amplitude is found to be 3 V. What is the modulation index?


Compute the LC product of a tuned amplifier circuit required to generate a carrier wave of 1 MHz for amplitude modulation.


A signal of 5 kHz frequency is amplitude modulated on a carrier wave of frequency 2 MHz. The frequencies of the resultant signal are ______. 


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×