Science (English Medium) कक्षा ११ - CBSE Question Bank Solutions

Two inclined frictionless tracks, one gradual and the other steep meet at A from where two stones are allowed to slide down from rest, one on each track . Will the stones reach the bottom at the same time? Will they reach there with the same speed? Explain. Given θ₁ = 30°, θ₂ = 60°, and h = 10 m, what are the speeds and times taken by the two stones?

Explain why it is easier to pull a lawn mower than to push it.

Find the components along the x, y, z axes of the angular momentum l of a particle, whose position vector is r with components x, y, z and momentum is p with components p_x, p_y and 'p_z`. Show that if the particle moves only in the x-y plane the angular momentum has only a z-component.

Two particles, each of mass m and speed v, travel in opposite directions along parallel lines separated by a distance d. Show that the angular momentum vector of the two particle system is the same whatever be the point about which the angular momentum is taken.

A solid cylinder of mass 20 kg rotates about its axis with angular speed 100 rad s^–1. The radius of the cylinder is 0.25 m. What is the kinetic energy associated with the rotation of the cylinder? What is the magnitude of the angular momentum of the cylinder about its axis?

Explain why friction is necessary to make the disc in Figure roll in the direction indicated

(a) Give the direction of frictional force at B, and the sense of frictional torque, before perfect rolling begins.

(b) What is the force of friction after perfect rolling begins?

Read the following statements below carefully and state, with reasons, if it is true or false.

The stretching of a coil is determined by its shear modulus.

The edge of an aluminium cube is 10 cm long. One face of the cube is firmly fixed to a vertical wall. A mass of 100 kg is then attached to the opposite face of the cube. The shear modulus of aluminium is 25 GPa. What is the vertical deflection of this face?

Fill in the blanks using the word(s) from the list appended with each statement

For the model of a plane in a wind tunnel, turbulence occurs at a ... speed for turbulence for an actual plane (greater / smaller)

Explain why To keep a piece of paper horizontal, you should blow over, not under, it

Explain why A spinning cricket ball in air does not follow a parabolic trajectory

Can Bernoulli’s equation be used to describe the flow of water through a rapid in a river? Explain.

In a test experiment on a model aeroplane in a wind tunnel, the flow speeds on the upper and lower surfaces of the wing are 70 m s^–1and 63 m s^–1 respectively. What is the lift on the wing if its area is 2.5 m²? Take the density of air to be 1.3 kg m^–3.

Figures (a) and (b) refer to the steady flow of a (non-viscous) liquid. Which of the two figures is incorrect? Why?

The cylindrical tube of a spray pump has a cross-section of 8.0 cm² one end of which has 40 fine holes each of diameter 1.0 mm. If the liquid flow inside the tube is 1.5 m min^–1, what is the speed of ejection of the liquid through the holes?

In deriving Bernoulli’s equation, we equated the work done on the fluid in the tube to its change in the potential and kinetic energy. (a) What is the largest average velocity of blood flow in an artery of diameter 2 × 10^–3 m if the flow must remain laminar? (b) Do the dissipative forces become more important as the fluid velocity increases? Discuss qualitatively.

A copper block of mass 2.5 kg is heated in a furnace to a temperature of 500 °C and then placed on a large ice block. What is the maximum amount of ice that can melt? (Specific heat of copper = 0.39 J g^–1 K^–1; heat of fusion of water = 335 J g^–1).

Answer the following question based on the P-T phase diagram of carbon dioxide:

Is CO₂ solid, liquid or gas at

1. –70 °C under 1 atm,
2. –60 °C under 10 atm,
3. 15 °C under 56 atm?

Answer the following questions based on the P–T phase diagram of CO₂:

CO₂ at 1 atm pressure and temperature – 60 °C is compressed isothermally. Does it go through a liquid phase?

Answer the following questions based on the P–T phase diagram of CO₂:

What happens when CO₂ at 4 atm pressure is cooled from room temperature at constant pressure?