Advertisements
Advertisements
प्रश्न
Which type of levers have mechanical advantage always more than 1? Give reasons.
Advertisements
उत्तर
The mechanical advantage of the second-order lever is always more than 1. This is because the effort arm is always longer than the load arm of these levers.
संबंधित प्रश्न
Class II levers are designed to have ______.
A 4 m long rod of negligible weight is to be balanced about a point 125 cm from one end and a load of 18 kgf is suspended at a point 60 cm from the support on the shorter arm.
- If a weight W is placed at a distance of 250 cm from the support on the longer arm to balance the rod, find W.
- If a weight 5 kgf is kept to balance the rod, find its position.
- To which class of lever does it belong?
Give three examples for leavers of 1st order.
The following belong to which class of lever?
A see-saw
The following belong to which class of lever?
Human-arm
The following belong to which class of lever?
Rowing of a boat
The following are an example of levers. State the class of lever to which each one belongs giving the relative positions of Load (L), Effort (E), Fulcrum (F):
(i) Scissors (ii) Sugar tongs (iii) Nutcracker (iv) Pliers.
In the following diagram of a wheelbarrow, mark the fulcrum (F) and indicate the directions of load (L) and effort (E) with arrows.
What class of lever is it? Give one more example of the same class of lever.
The diagram below shows a lever in use.
(i) To which class of lever does it belong?
(ii) If FA = 40 cm, AB = 60 cm, then find the mechanical advantage of the lever.
The length of a nut-cracker is 12 cm. A nut, when kept at a distance of 4 cm from its fulcrum, requires an effort of 100 gf to crack it. What force will be required to crack the nut without using the nut-cracker?
