Advertisements
Advertisements
प्रश्न
What is the excess pressure inside a bubble of soap solution of radius 5.00 mm, given that the surface tension of soap solution at the temperature (20 °C) is 2.50 × 10–2 N m–1? If an air bubble of the same dimension were formed at depth of 40.0 cm inside a container containing the soap solution (of relative density 1.20), what would be the pressure inside the bubble? (1 atmospheric pressure is 1.01 × 105 Pa).
Advertisements
उत्तर १
Here surface tension of soap solution at room temperature
T = 2.50 x 10-2 Nm-1, radius of soap bubble, r = 5.00 mm = 5.00 x 10-3 m.
:. Excess pressure inside soap bubble, `p = p_i - p_0 = (4T)/r`
`= (4xx2.50xx10^(-2))/(5.00xx10^(-3)) = 20.0 Pa`
When an air bubble of radius `r = 5.00 xx 10^(-3)` m is formed at a depth h = 40.0 cm = 0.4 m inside a container containing a soap solution of relative density 1.20 or density `rho = 1.20 xx 10^3 kg m^(-3)`, then excess pressure
`P = P_i - P_0 = (2T)/r`
`:. P_i = P_0 + (2T)/r = (P_a + hrhog) + (2T)/r`
`=[1.01 xx 10^5 + 0.4 xx 1.2 xx 10^3 xx 9.8 + (2xx2.50xx10^(-2))/(5.00xx10^(-3))] Pa`
`= (1.01 xx 10^5 + 4.7 xx 10^3 + 10.0)Pa`
`= 1.06 xx 10^5` Pa
उत्तर २
Excess pressure inside the soap bubble is 20 Pa;
Pressure inside the air bubble is `1.06 xx 10^5 Pa`
Soap bubble is of radius, r = 5.00 mm = 5 × 10–3 m
Surface tension of the soap solution, S = 2.50 × 10–2 Nm–1
Relative density of the soap solution = 1.20
∴Density of the soap solution, ρ = 1.2 × 103 kg/m3
Air bubble formed at a depth, h = 40 cm = 0.4 m
Radius of the air bubble, r = 5 mm = 5 × 10–3 m
1 atmospheric pressure = 1.01 × 105 Pa
Acceleration due to gravity, g = 9.8 m/s2
Hence, the excess pressure inside the soap bubble is given by the relation:
`P = 4S/r`
`= (4xx2.5xx10^(-2))/(5xx10^(-3))`
= 20 Pa
Therefore, the excess pressure inside the soap bubble is 20 Pa.
The excess pressure inside the air bubble is given by the relation:
`P = (2S)/r`
`= (2xx2.5xx10^(-2))/(5xx10^(-3))`
= 10 Pa
Therefore, the excess pressure inside the air bubble is 10 Pa.
At a depth of 0.4 m, the total pressure inside the air bubble
= Atmospheric pressure + hρg + P’
`= 1.01 xx 10^5 +0.4 xx 1.2 xx 10^3 xx 9.8 + 10`
`= 1.057 xx 10^5 Pa`
`= 1.06 xx 10^(5) Pa`
Therefore, the pressure inside the air bubble is `1.06 xx 10^5 Pa`
संबंधित प्रश्न
State any two characteristics of the angle of contact
If more air is pushed in a soap bubble, the pressure in it
Which of the following graphs may represent the relation between the capillary rise hand the radius r of the capillary?
The lower end of a capillary tube is immersed in mercury. The level of mercury in the tube is found to be 2 cm below the outer level. If the same tube is immersed in water, up to what height will the water rise in the capillary?
A capillary tube of radius 0.50 mm is dipped vertically in a pot of water. Find the difference between the pressure of the water in the tube 5.0 cm below the surface and the atmospheric pressure. Surface tension of water = 0.075 N m−1.
Consider an ice cube of edge 1.0 cm kept in a gravity-free hall. Find the surface area of the water when the ice melts. Neglect the difference in densities of ice and water.
A cubical block of ice floating in water has to support a metal piece weighing 0.5 kg. Water can be the minimum edge of the block so that it does not sink in water? Specific gravity of ice = 0.9.
A cubical metal block of edge 12 cm floats in mercury with one fifth of the height inside the mercury. Water in it. Find the height of the water column to be poured.
Specific gravity of mercury = 13.6.
Twenty-seven droplets of water, each of radius 0.1 mm coalesce into a single drop. Find the change in surface energy. Surface tension of water is 0.072 N/m.
A square frame of each side L is dipped in a soap solution and taken out. The force acting on the film formed is _____.
(T = surface tension of soap solution).
If the surface tension of a soap solution is 3 × 10-2 N/m then the work done in forming a soap film of 20 cm × 5 cm will be ______.
Under isothermal conditions, two soap bubbles of radii 'r1' and 'r2' coalesce to form a big drop. The radius of the big drop is ______.
Soap solution is used for cleaning dirty clothes because ______.
What is surface tension? Explain the applications of surface tension.
The sufrace tension and vapour pressure of water at 20°C is 7.28 × 10–2 Nm–1 and 2.33 × 103 Pa, respectively. What is the radius of the smallest spherical water droplet which can form without evaporating at 20°C?
Two narrow bores of diameter 5.0 mm and 8.0 mm are joined together to form a U-shaped tube open at both ends. If this U-tube contains water, what is the difference in the level of the two limbs, of the tube?
[Take surface tension of water T = 7.3 × 10-2 Nm-1, angle of contact = 0, g = 10 ms-2 and density of water = 1.0 × 103 kgm-3]
A coaxial cylinder made of glass is immersed in liquid of surface tension ' S'. Radius of inner and outer surface of cylinder are R1 and R2 respectively. Height till which liquid will rise is (Density of liquid is p):
In most liquids, with the rise in temperature, the surface tension of a liquid ______.
